Investigation of H{sup -} production by surface interaction of the plasma generated in ''Camembert III'' reactor via distributed electron cyclotron resonance at 2.45 GHz (abstract)
- Laboratoire de Physique Subatomique et de Cosmologie (UJF, CNRS IN2P3 et ST2I, INPG), Centre de Recherche Plasmas-Materiaux-Nanostructures, 53 rue des Martyrs, 38026 Grenoble Cedex (France)
When considering the state-of-the-art on H{sup -} ion sources, ions can be produced either by plasma-surface interaction and/or inside the plasma volume. For the production of negative ions by surface ionization, a low work function material is required. For this purpose, cesium has been used in many cases at LBNL, JAEA, KEK, and in other facilities [M. Bacal, Nucl. Fusion 46, 250 (2006)]. Despite an enhancement in the negative ion production (by a factor of 2.5 in JAEA source), the use of cesium could lead to many drawbacks in the plasma functioning of ITER, for example. An alternative material to cesium could lead to an important improvement for negative ion source.For this purpose, both theoretical and experimental studies must be undertaken. Surface mechanisms have to be taken into account both for creation and loss mechanisms: (i) By recycling the atomic hydrogen into highly vibrationally excited molecular hydrogen via recombinative desorption on specific surfaces (fresh tantalum on surface increases the negative ion density [M. Bacal, A. A. Ivanov, Jr. et al., Rev. Sci. Instrum. 75, 1699 (2004)] by more than 60%). It has been shown for a rigid substrate model that both the recombination cross section and the degree of vibrational excitation are highly sensitive to the nature of the surface [B. Jackson and D. Lemoine, J. Chem. Phys. 114, 474 (2001)].(ii)By surface passivation, which could lead to a substantial decrease in H{sub 2} (X,v{sup ''}) wall losses.In order to understand the fundamental mechanisms of surface production and losses, 'Camembert III' experimental setup, recently settled in the LPSC laboratory (Grenoble, France) is used. In this experimental structure, hydrogen multidipolar plasma sustained by microwaves (2.45 GHz) presents the potential advantage to operate either in a metallic or a conductive chamber. The inner walls could be then frequently coated, by sputtering or chemical vapor deposition techniques, with no opening of the chamber with various materials. First experiments of H{sup -} surface production will be performed on target material. Hence, perfectly knowing the target material (in terms of composition and structural and physical properties), H{sup -} ion density production near the target surface will be monitored by laser photodetachment [M. Bacal, Rev. Sci. Instrum. 71, 3981 (2000)]. Even if this diagnostic gives no direct information on high rovibrationally excited level of the H{sub 2} molecule, its implementation and use are far less complicated than vuv LIF.
- OSTI ID:
- 21103921
- Journal Information:
- Review of Scientific Instruments, Vol. 79, Issue 2; Conference: ICIS 2007: 12. international conference on ion sources, Jeju (Korea, Republic of), 26-31 Aug 2007; Other Information: DOI: 10.1063/1.2821592; (c) 2008 American Institute of Physics; Country of input: International Atomic Energy Agency (IAEA); ISSN 0034-6748
- Country of Publication:
- United States
- Language:
- English
Similar Records
Future carbon beams at SPIRAL1 facility: Which method is the most efficient?
Cybele: A large size ion source of modular construction for the Tore-Supra diagnostic injector
Related Subjects
CESIUM
CHEMICAL VAPOR DEPOSITION
DESORPTION
ELECTRON CYCLOTRON-RESONANCE
EXCITED STATES
FAR ULTRAVIOLET RADIATION
GHZ RANGE 01-100
HYDROGEN
HYDROGEN IONS 1 MINUS
ION DENSITY
ION SOURCES
ITER TOKAMAK
LITHIUM FLUORIDES
MICROWAVE RADIATION
PLASMA
SURFACE IONIZATION
WALL EFFECTS
WORK FUNCTIONS