Finite Element Modelling of the Sawing of DC Cast AA2024 Aluminium Alloy Slabs
- Computational Materials Laboratory, School of Engineering, Ecole Polytechnique Federale de Lausanne, Station 12, CH-1015 Lausanne (Switzerland)
- Calcom-ESI SA, PSE-A, CH-1015 Lausanne (Switzerland)
- Alcan Aluminium Valais SA, CH3960 Sierre (Switzerland)
In the semi-continuous casting of large cross-section rolling sheet ingots of high-strength aluminum alloys (2xxx and 7xxx series), the control of the residual (internal) stresses generated by the non-uniform cooling becomes a necessity. These stresses must be relieved by a thermal treatment before the head and foot of the ingot can be cut. Otherwise, the saw can be caught owing to compressive stresses or cut parts may be ejected thus injuring people or damaging equipment. These high added-value ingots need to be produced in secure conditions. Moreover, a better control of the sawing procedure could allow the suppression of the thermal treatment and therefore save time and energy. By studying the stress build-up during casting and the stress relief during sawing, key parameters for the control and optimization of the processing steps, can be derived. To do so, the direct chill (DC) casting of the AA2024 alloy is modeled with ABAQUS 6.5 with special attention to the thermo-mechanical properties of the alloy. The sawing operation is then simulated by removing mesh elements so as to reproduce the progression of the saw in the ingot. Preliminary results showing the stress relief during sawing accompanied by the risk of saw blocking due to compression or initiating a crack ahead of the saw, are analyzed with an approach based on the rate of strain energy release.
- OSTI ID:
- 21056983
- Journal Information:
- AIP Conference Proceedings, Journal Name: AIP Conference Proceedings Journal Issue: 1 Vol. 907; ISSN APCPCS; ISSN 0094-243X
- Country of Publication:
- United States
- Language:
- English
Similar Records
Numerical and experimental study of rolling faces pull-in during direct chill casting of aluminum alloys
Computer simulation of solidification cracking in high strength aluminum alloys: Basic concepts and approach