The effect of particle reinforcement on the creep behavior of single-phase aluminum
- General Motors R and D Center, Warren, MI (United States)
- Univ. of Michigan, Ann Arbor, MI (United States). Dept. of Materials Science and Engineering
- Ford Motor Co., Dearborn, MI (United States)
The effect of TiC particle reinforcement on the creep behavior of Al (99.8) and Al-1.5Mg is investigated in the temperature range of 150 C to 250 C. The dislocation structure developed during creep is characterized in these materials. The addition of TiC increases creep resistance in both alloys. In pure aluminum, the presence of 15 vol pct TiC leads to a factor of 400 to 40,000 increase in creep resistance. The creep strengthening observed in Al/TiC/15{sub p} is substantially greater than the direct strengthening predicted by continuum models. Traditional methods for explaining creep strengthening in particle-reinforced materials (e.g., threshold stress, constant structure, and dislocation density) are unable to account for the increase in creep resistance. The creep hardening rate (h) is found to be 100 times higher in Al/TiC/15{sub p} than in unreinforced Al. When incorporated into a recovery creep model, this increase in h can explain the reduction in creep rate in Al/TiC/15{sub p}. Particle reinforcement affects creep hardening, and thus creep rate, by altering the equilibrium dislocation substructure that forms during steady-state creep. The nonequilibrium structure generates internal stresses which lower the rate of dislocation glide. The strengthening observed by adding TiC to Al-1.5Mg is much smaller than that found in the pure aluminum materials and is consistent with the amount of strengthening predicted by continuum models. These results show that while both direct (continuum) and indirect strengthening occur in particle-reinforced aluminum alloys, the ratio of indirect to direct strengthening is strongly influenced by the operative matrix strengthening mechanisms.
- Sponsoring Organization:
- USDOE
- OSTI ID:
- 205245
- Report Number(s):
- CONF-940204--
- Journal Information:
- Metallurgical Transactions, A, Journal Name: Metallurgical Transactions, A Journal Issue: 12 Vol. 26; ISSN 0360-2133; ISSN MTTABN
- Country of Publication:
- United States
- Language:
- English
Similar Records
Micromechanics effects in creep of metal-matrix composites
Temperature dependence of the optimum particle size for the dislocation detachment controlled creep of Al-Fe-V-Si/SiC{sub p} composite