Quantitative measurement of fatigue crack initiation and propagation in 304 stainless steel as related to design and nondestructive evaluation. Ph.D. Thesis
The initiation and propagation of short fatigue cracks in 304 stainless steel have been examined through replication techniques and through a mechanical vibration resonant frequency technique, which allows the measurement of elastic modulus and internal friction. Center hole and side notch specimens 6.3 mm thick were used for low cycles fatigue tests. The notches localize the crack initiation sites to facilitate the observation of the cracks and also simulate stress risers in real parts. The cracks initiate at several locations at the notch root inside the notches. These cracks then grow and link up along the surface of the notches and propagate to the specimen surface. The cracks are often nonlinear and link up through a bridging feature. Once the crack has reached the specimen surfaces at the edges of the notch, it propagates through the specimen as a through crack. The crack profile at this point has a small amount of curvature, allowing a measurement of the crack length through surface examination. The stress intensity factor is used as the driving force for the small crack propagation. Justification for the linear elastic fracture mechanics based stress intensity factor is found through examination of the cyclic stress-strain curves. The maximum amount of plastic strain is a factor of five less than the 0.2 percent plastic strain used to define the yield strength. Therefore, there is no gross yielding. The plastic zone size due to the notch was also calculated and found to be smaller than the crack length in most cases. Finally, the elastic plastic fracture mechanics based delta J was calculated for the specimen which experienced the maximum plastic strain. Only a small difference is found between the elastic delta K(exp 2)/E term and delta J. The short cracks grew at stress intensity factors below the long crack threshold. The crack growth rate of the small cracks fit a power law relation commonly called the Paris relation.
- Research Organization:
- Northwestern Univ., Evanston, IL (United States)
- OSTI ID:
- 200627
- Resource Relation:
- Other Information: TH: Ph.D. Thesis; PBD: 1993
- Country of Publication:
- United States
- Language:
- English
Similar Records
Notch and temperature effects on crack propagation in SS 304 under LCF conditions
The crack-tip mechanics and growth rates of small fatigue cracks in ASTROLOY