skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Modeling the Yaw Behavior of Tail Fins for Small Wind Turbines: November 22, 2021 - May 21, 2024

Technical Report ·
DOI:https://doi.org/10.2172/1989234· OSTI ID:1989234
 [1];  [2];  [3]
  1. Port Said Univ. (Egypt)
  2. Univ. of Calgary, AB (Canada)
  3. National Renewable Energy Laboratory (NREL), Golden, CO (United States)

This report describes the aerodynamic modelling of the yaw behavior of tail fins for small wind turbines (SWTs). The analysis is based on unsteady slender body theory (USBT) and is formulated to be used with the proposed tail fin module to be added to OpenFAST. Linearized USBT, which has been applied in the past to SWT tail fins, is developed in three main ways. First, USBT is extended to high yaw angles and aspect ratios by modelling the associated nonlinear vortex dynamics and the chordwise load distribution respectively. Second, we consider the effect of time-varying wind speed. The extended theory is compared to recent unpublished measurements at the University of Perugia, Italy, for the yaw behavior of delta, elliptical, and rectangular tail fins without a rotor and nacelle. The fins were released from initial yaw angles of -40 degrees and -80 degrees ; the latter is of sufficient magnitude to show the importance of the nonlinear yaw dynamics. Further, the friction in the model tail fin bearings was measured and modelled. The constants in the aerodynamic models were taken from the literature but significant improvement in accuracy is achieved by using system identification techniques to optimize the values. This leads to the third main finding: extended USBT is accurate for all generic tail fin shapes that we considered and is, therefore, very suitable for inclusion in aeroelastic codes for SWTs. The final development is of a general nonlinear equation for yaw response that is simpler than the extended USBT and is also suitable for inclusion in OpenFAST. The two nonlinear models are used to highlight the geometric requirements for good tail fin design.

Research Organization:
National Renewable Energy Laboratory (NREL), Golden, CO (United States)
Sponsoring Organization:
USDOE Office of Energy Efficiency and Renewable Energy (EERE), Renewable Power Office. Wind Energy Technologies Office
DOE Contract Number:
AC36-08GO28308
OSTI ID:
1989234
Report Number(s):
NREL/SR-5000-86044; MainId:86817; UUID:021115fe-1fe9-49d7-a0d9-a4efe1f144d7; MainAdminID:69887
Country of Publication:
United States
Language:
English

Similar Records

Simplified aeroelastic modeling of horizontal-axis wind turbines
Technical Report · Wed Sep 01 00:00:00 EDT 1982 · OSTI ID:1989234

Analysis of wind turbines in yaw
Technical Report · Thu Sep 01 00:00:00 EDT 1983 · OSTI ID:1989234

Comparison of free vortex wake and blade element momentum results against large-eddy simulation results for highly flexible turbines under challenging inflow conditions
Journal Article · Fri Mar 24 00:00:00 EDT 2023 · Wind Energy Science (Online) · OSTI ID:1989234