skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Study on divertor detachment and pedestal characteristics in the DIII-D upper closed divertor

Journal Article · · Nuclear Fusion

Abstract Experiments performed in DIII-D demonstrate that higher plasma current and heating power combined with impurity seeding facilitate the achievement of divertor detachment with a higher pedestal pressure and higher plasma performance in H-mode plasmas with a baffled closed divertor compared with an open divertor. Dedicated experiments were carried out to study the impact of power, plasma current and impurity seeding on divertor detachment with ion B × B directed into the divertor favorable for the L–H transition. With a factor of three variation in heating power and with only D2 puffing, no significant difference in the separatrix density at detachment onset was found. The higher heating power leads to higher impurity concentration and wider scrape-off layer (SOL) width, and reduces the detachment onset density to one similar to that in lower-power plasmas. Higher current requires higher pedestal and line-averaged densities to achieve divertor detachment; however, the increase in separatrix density at increasing plasma current is found to be less pronounced. Initial calculations found that both power scan and plasma current scan datasets are qualitatively consistent with theory after considering the change in impurity concentration and heat flux width. This also motivates the future extensive study of transport and divertor impurity behavior in order to have a quantitative comparison between experiment and theory. Compared with an open divertor, a closed divertor facilitates detachment onset at ∼40% lower line-averaged plasma density. Additional N2 seeding facilitates the achievement of detachment at a lower separatrix density and thus a higher pedestal temperature, which is beneficial for advanced tokamak scenarios. Higher heating power requires a higher N2 puffing rate to achieve the same degree of detachment, while a higher N2 puffing rate leads to lower detachment onset line-averaged density, both of which agree with theory. In contrast to the narrower pedestal in an open divertor approaching detachment, the pedestal density width in a closed divertor increases with density. The density gradient increases with line-averaged density at higher plasma current, but remains nearly unchanged at lower plasma current. In particular, compared with discharges with low power, at high heating power the pedestal density gradient is much weaker, while the SOL density is significantly higher and wider. At the same plasma current, both pedestal pressure gradient and temperature gradient decrease linearly with the line-averaged density but remain similar across different heating powers. Even with different plasma current and heating power, the normalized pressure gradient remains identical. As a result, achievement of divertor detachment with a higher pedestal pressure and higher plasma performance is shown in a closed divertor, which is important for improving core–edge integration as one of the critical issues for future tokamak fusion reactors.

Research Organization:
General Atomics, San Diego, CA (United States); Lawrence Livermore National Laboratory (LLNL), Livermore, CA (United States)
Sponsoring Organization:
USDOE Office of Science (SC), Fusion Energy Sciences (FES); USDOE National Nuclear Security Administration (NNSA)
Grant/Contract Number:
AC02-09CH11466; FC02-04ER54698; NA0003525; AC05-00OR22725; SC0019256; AC52-07NA27344
OSTI ID:
1926777
Alternate ID(s):
OSTI ID: 1909971; OSTI ID: 1960054; OSTI ID: 2282409
Report Number(s):
LLNL-JRNL-857630
Journal Information:
Nuclear Fusion, Journal Name: Nuclear Fusion Vol. 63 Journal Issue: 4; ISSN 0029-5515
Publisher:
IOP PublishingCopyright Statement
Country of Publication:
IAEA
Language:
English

References (42)

Fueling with edge recycling to high-density in DIII-D journal July 2013
MHD stability constraints on divertor heat flux width in DIII-D journal December 2020
Separating divertor closure effects on divertor detachment and pedestal shape in DIII-D journal March 2020
Initial results of the high resolution edge Thomson scattering upgrade at DIII-D journal October 2012
Plasma detachment in JET Mark I divertor experiments journal March 1998
Heat flux mitigation by impurity seeding in high-field tokamaks journal January 2017
Divertor impurity seeding experiments at the COMPASS tokamak journal September 2019
Experimental evidence of enhanced recombination of a hydrogen plasma induced by nitrogen seeding in linear device Magnum-PSI journal May 2019
Dependence of neutral pressure on detachment in the small angle slot divertor at DIII-D journal May 2019
Correlation of the tokamak H-mode density limit with ballooning stability at the separatrix journal January 2018
Effects of divertor electrical drifts on particle distribution and detachment near the divertor target plate in DIII-D journal May 2021
Plasma detachment in divertor tokamaks journal February 2018
Integration of full divertor detachment with improved core confinement for tokamak fusion plasmas journal March 2021
Observation of fully detached divertor integrated with improved core confinement for tokamak fusion plasmas journal May 2021
Parameter dependencies of the experimental nitrogen concentration required for detachment on ASDEX Upgrade and JET journal September 2021
Identifying the location of the OMP separatrix in DIII-D using power accounting journal August 2015
Compatibility of separatrix density scaling for divertor detachment with H-mode pedestal operation in DIII-D journal July 2017
Temporal evolution of H-mode pedestal in DIII-D journal March 2009
E × B Flux Driven Detachment Bifurcation in the DIII-D Tokamak journal August 2018
The effect of divertor closure on detachment onset in DIII-D journal May 2019
Effects of divertor geometry and chemical sputtering on impurity behaviour and plasma performance in JET journal March 2000
Dissociative recombination process of ammonium for HN-MAR in high density D-N plasmas journal December 2018
Broadening of the power fall-off length in a high density, high confinement H-mode regime in ASDEX Upgrade journal March 2021
Heuristic drift-based model of the power scrape-off width in low-gas-puff H-mode tokamaks journal December 2011
Reverse flow and parameter profiles in a dense tokamak divertor plasma journal November 1992
Study of near scrape-off layer (SOL) temperature and density gradient lengths with Thomson scattering journal November 2015
Scaling of the tokamak near the scrape-off layer H-mode power width and implications for ITER journal August 2013
Design and operation of the multipulse Thomson scattering diagnostic on DIII‐D (invited) journal October 1992
A gyrokinetic perspective on the JET-ILW pedestal journal January 2017
Analysis of a multi-machine database on divertor heat fluxes journal May 2012
Experimental study of detachment density threshold in L-mode plasmas on EAST journal May 2020
Partial detachment of high power discharges in ASDEX Upgrade journal April 2015
Analysis of edge stability for models of heat flux width journal August 2017
A new scaling for divertor detachment journal March 2017
Can detached divertor plasmas be explained as self-sustained gas targets? journal November 1993
Role of the separatrix density in the pedestal performance in deuterium low triangularity JET-ILW plasmas and comparison with JET-C journal November 2021
Improved core-edge compatibility using impurity seeding in the small angle slot (SAS) divertor at DIII-D journal June 2020
Effects of divertor geometry on H-mode pedestal structure in attached and detached plasmas in the DIII-D tokamak journal July 2018
Impurity seeding for tokamak power exhaust: from present devices via ITER to DEMO journal November 2013
Effects of low-Z and high-Z impurities on divertor detachment and plasma confinement journal August 2017
Enhanced H-mode pedestals with lithium injection in DIII-D journal May 2015
An assessment of nitrogen concentrations from spectroscopic measurements in the JET and ASDEX upgrade divertor journal January 2019

Similar Records

Anisotropic flow and flow fluctuations of identified hadrons in Pb–Pb collisions at $ \sqrt{s_{\textrm{NN}}}$ = 5.02 TeV
Journal Article · Wed May 31 00:00:00 EDT 2023 · Journal of High Energy Physics (Online) · OSTI ID:1926777

Luminous signals of inelastic dark matter in large detectors
Journal Article · Mon Sep 16 00:00:00 EDT 2019 · Journal of High Energy Physics (Online) · OSTI ID:1926777

Measurement of beauty and charm production in pp collisions at $\sqrt{s}$ = 5.02 TeV via non-prompt and prompt D mesons
Journal Article · Mon May 24 00:00:00 EDT 2021 · Journal of High Energy Physics (Online) · OSTI ID:1926777