Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

Conversion Kinetics and Ionic Conductivity in Na-β”-Alumina + YSZ (Naβ”AY) Sodium Solid Electrolyte via Vapor Phase Conversion Process

Journal Article · · Membranes
 [1];  [2]
  1. University of Utah, Salt Lake City, UT (United States); Chinese Academy of Sciences (CAS), Ningbo (China); Univ. of Utah, Salt Lake City, UT (United States)
  2. University of Utah, Salt Lake City, UT (United States)

Sodium ion batteries have been receiving increasing attention and may see potential revival in the near future, particularly in large-scale grid energy storage coupling with wind and solar power generation, due to the abundant sodium resources, low cost, and sufficiently high energy density. Among the known sodium ion conductors, the Na-β”-alumina electrolyte remains highly attractive because of its high ionic conductivity. This study focuses on the vapor phase synthesis of a Na-β”-Alumina + YSZ (Naβ”AY) composite sodium electrolyte, which has higher mechanical strength and stability than conventional single phase β”-Alumina. The objectives are the measurement of conversion kinetics through a newly developed weight-gain based model and the determination of sodium ionic conductivity in the composite electrolyte. Starting samples contained ~70 vol% α-Alumina and ~30 vol% YSZ (3 mol% Y2O3 stabilized Zirconia) with and without a thin alumina surface layer made by sintering in air at 1600 °C. The sintered samples were placed in a powder of Na-β”-alumina and heat-treated at 1250 °C for various periods. Sample dimensions and weight were measured as a function of heat treatment time. The conversion of α-Alumina in the α-Alumina + YSZ composite into Naβ”AY occurred by coupled diffusion of sodium ions through Na-β”-alumina and of oxygen ions through YSZ, effectively diffusing Na2O. From the analysis of the time dependence of sample mass and dimensions, the effective diffusion coefficient of Na2O through the sample, Deff, was estimated to be 1.74 x 10-7 cm2 s-1, and the effective interface transfer parameter, keff, was estimated as 2.33 x 10-6 cm s-1. By depositing a thin alumina coating layer on top of the bulk composite, the chemical diffusion coefficient of oxygen through single phase Na-β”-alumina was estimated as 4.35 x 10-10 cm2 s-1. An AC impedance measurement was performed on a fully converted Naβ”AY composite, and the conductivity of the composite electrolyte was 1.3 x 10-1 S cm-1 at 300 °C and 1.6 x 10-3 S cm-1 at 25 °C, indicating promising applications in solid state or molten salt batteries at low to intermediate temperatures.

Research Organization:
University of Utah, Salt Lake City, UT (United States)
Sponsoring Organization:
USDOE Office of Science (SC); National Science Foundation (NSF)
Grant/Contract Number:
FG02-03ER46086
OSTI ID:
1904680
Journal Information:
Membranes, Journal Name: Membranes Journal Issue: 6 Vol. 12; ISSN 2077-0375
Publisher:
MDPICopyright Statement
Country of Publication:
United States
Language:
English

References (25)

Sodium Plating from Na‐β″‐Alumina Ceramics at Room Temperature, Paving the Way for Fast‐Charging All‐Solid‐State Batteries journal December 2019
A Superior Low-Cost Cathode for a Na-Ion Battery journal January 2013
From High‐ to Low‐Temperature: The Revival of Sodium‐Beta Alumina for Sodium Solid‐State Batteries journal September 2021
Lithium conductivity and lithium diffusion in NASICON-type Li1+xTi2–xAlx(PO4)3 (x= 0; 0.3) prepared by mechanical activation journal January 2008
High efficiency thermoelectric conversion with beta″-alumina electrolytes, the sodium heat engine journal October 1981
Zebra batteries journal August 1994
Current trends and future challenges of electrolytes for sodium-ion batteries journal January 2016
Low temperature performance of sodium–nickel chloride batteries with NaSICON solid electrolyte journal December 2015
Ceramic and polymeric solid electrolytes for lithium-ion batteries journal August 2010
Comparative study of EC/DMC LiTFSI and LiPF6 electrolytes for electrochemical storage journal November 2011
Enhanced sintering of β″-Al2O3/YSZ with the sintering aids of TiO2 and MnO2 journal November 2015
Constructing effective interface for room-temperature Beta-Al2O3 based sodium metal batteries journal March 2022
Effects of fabrication conditions on mechanical properties and microstructure of duplex β″-Al2O3 solid electrolyte journal July 2015
Inorganic solid Li ion conductors: An overview journal June 2009
Li mobility in Li0.5−xNaxLa0.5TiO3 perovskites (0≤x≤0.5)Influence of structural and compositional parameters journal October 2009
Synthesis of lithium-beta-alumina by various ion-exchange and conversion processes journal July 2012
Performance analysis of Na-β″-Al2O3/YSZ solid electrolytes produced by conventional sintering and by vapor conversion of α-Al2O3/YSZ journal February 2020
Advanced intermediate temperature sodium–nickel chloride batteries with ultra-high energy density journal February 2016
Advanced intermediate-temperature Na–S battery journal January 2013
Cell degradation of a Na–NiCl2 (ZEBRA) battery journal January 2013
Development of Surface Compressive Stresses in Zirconia-Alumina Composites by an Ion-Exchange Process journal December 2004
Vapor Phase Conversion of α-Alumina + Zirconia Composites into Sodium Ion Conducting Na-β -Alumina + Zirconia Solid Electrolytes journal January 2013
Sodium, Silver and Lithium-Ion Conducting β″-Alumina + YSZ Composites, Ionic Conductivity and Stability journal March 2021
Large Planar Na-β″-Al2O3 Solid Electrolytes for Next Generation Na-Batteries journal January 2020
Fabrication of a Full-Scale Pilot Model of a Cost-Effective Sodium Nickel-Iron Chloride Battery Over 40 Ah journal November 2021