Dimensional stability of low-cost thermoplastic composite molds

Technical Report · Wed Jan 05 04:00:00 EST 2022

DOI:https://doi.org/10.2172/1838303· OSTI ID:1838303

Jayaraman, K. ^[1]; Dereims, Arnaud ^[2]; Ejsmont, Daniel ^[1]; Raveendra, Ravi ^[2]; Shree, Swayam ^[1]

---

1. Michigan State Univ., East Lansing, MI (United States)
2. ESI North America, Inc., San Diego CA (United States)

This report addresses a key question for using additively manufactured tooling from carbon fiber reinforced thermoplastic composites. How does the distortion of the molded part change with the print orientation used in the manufacture of tooling? The objective of this research was to discuss the distortion of parts molded with such tooling, in relation to the deflections in the tooling during the compression molding process. This was achieved through both model simulations and experimental molding runs. A vertical orientation was used in printing the mold with a distinctly non-planar surface: this orientation allowed for higher performance along the press closing direction -- higher thermal conductivity, higher stiffness, and lower coefficient of thermal expansion. Epoxy-carbon fiber twill weave fabric prepreg was then compression molded in this mold. The thermomechanical properties of the tooling material and the molded part were measured and used in simulation of mold deformation as well as part distortion. The thermomechanical anisotropy of the mold is quite different from that of the molded part because in the mold, the stiffest direction is the z-axis, while in the molded thermoset part, the z-axis is the weakest direction. The connection between mold deformation during the compression molding process and the final part distortion can be seen from the simulation results. The simulation results for the case where the mold was four times as stiff as the part along the press closing direction compared well with experiment. When the mold stiffness was lowered in relation to the part stiffness, the mold deformation during the compression molding increased; but this led to a smaller extent of part distortion.

• Research Organization: Institute for Advanced Composites Manufacturing Innovation (IACMI), Knoxville, TN (United States)
• Sponsoring Organization: USDOE Office of Energy Efficiency and Renewable Energy (EERE), Energy Efficiency Office. Advanced Manufacturing Office
• DOE Contract Number: EE0006926
• OSTI ID: 1838303
• Report Number(s): IACMI--R009-2021-3.16; PA16-0349-3.16-01
• Country of Publication: United States
• Language: English

Related Subjects

36 MATERIALS SCIENCE
Additively manufactured tooling
carbon fiber
compression molding
simulation
thermoplastic