Measurement of Convective Heat Transfer Coefficients With Supercritical CO₂ Using the Wilson-Plot Technique

Journal Article · Wed Apr 08 00:00:00 EDT 2020 · Journal of Energy Resources Technology

DOI:https://doi.org/10.1115/1.4046700· OSTI ID:1827884

Black, James ^[1]; Straub, Douglas ^[2]; Robey, Edward ^[2]; Yip, M. Joseph ^[2]; Ramesh, Sridharan ^[3]; Roy, Arnab ^[3]; Searle, Matthew ^[4]

---

1. National Energy Technology Lab. (NETL), Pittsburgh, PA (United States)
2. National Energy Technology Lab. (NETL), Morgantown, WV (United States)
3. National Energy Technology Lab. (NETL), Morgantown, WV (United States); West Virginia Research Corporation, Morgantown, WV (United States)
4. National Energy Technology Lab. (NETL), Morgantown, WV (United States); Oak Ridge Inst. for Science and Education, Morgantown, WV (United States)

This paper describes the measurement of convective heat transfer coefficients and friction factors for sCO₂ flowing in a smooth tube and compares the results with published correlations for validation. The paper also describes the Heat Exchange and Experimental Testing (HEET) rig recently designed and built at the U.S. Department of Energy’s (DoE’s) National Energy Technology Laboratory (NETL) in Morgantown, WV. Here, the Wilson-plot technique used for measuring the heat transfer coefficients is described along with the data reduction process. The Wilson-plot technique was chosen as the basis for the design of NETL’s HEET rig. Advantages of the Wilson-plot technique include the (1) ability to measure high convective heat transfer coefficients accurately, (2) ability to measure average heat transfer coefficient for complicated heat exchange geometries like those produced using additive manufacturing, (3) ability to measure heat transfer coefficients on both sides of a heat exchanger independently, and (4) simplicity of experimental setup. Capabilities of the HEET rig include pressure to 24 MPa (3500 psig), temperature to 538 °C (1000 °F), mass flow rate to 1.5 kg/s (3 lb/s), and Re to 500,000. The rig is designed to operate with pure CO₂ or a mixture of CO₂ and up to 10% N2 by volume to study the impact of gas mixtures typical of direct-fired sCO₂ power cycles on the convective heat transfer and pressure drop. Preliminary tests in the HEET rig were performed with smooth stainless-steel tube and pure CO₂, and the results were compared with published correlations for Nusselt number (Nu) and friction factor. Over a Reynolds number (Re) range from 58,000 to 228,000, measured Nu was compared to predictions using the Dittus and Boelter equation (Kreith and Bohn, 1993, “Principles of Heat Transfer, West Publishing Company”) within 5% and measured friction factors were compared to predictions using the McAdams correlation (“McAdams, 1954, “Heat Transmission,” 3rd ed., McGraw Hill, New York)” for smooth tube to be within 5%.

• Research Organization: National Energy Technology Laboratory (NETL), Pittsburgh, PA, Morgantown, WV, and Albany, OR (United States)
• Sponsoring Organization: USDOE Office of Fossil Energy (FE)
• OSTI ID: 1827884
• Report Number(s): DOE/NETL--2021/2658
• Journal Information: Journal of Energy Resources Technology, Journal Name: Journal of Energy Resources Technology Journal Issue: 7 Vol. 142; ISSN 0195-0738
• Publisher: ASME
• Country of Publication: United States
• Language: English

Related Subjects

42 ENGINEERING
Wilson-plot technique
convective heat transfer coefficient
energy conversion/systems
energy systems analysis