Drilling plastic formations using highly polished PDC cutters
- and others
Highly plastic and over-pressured formations are troublesome for both roller cone and PDC bits. Thus far, attempts to increase penetration rates in these formations have centered around re-designing the bit or modifying the cutting structure. These efforts have produced only moderate improvements. This paper presents both laboratory and field data to illustrate the benefits of applying a mirror polished surface to the face of PDC cutters in drilling stressed formations. These cutters are similar to traditional PDC cutters, with the exception of the reflective mirror finish, applied to the diamond table surfaces prior to their installation in the bit. Results of tests conducted in a single point cutter apparatus and a full-scale drilling simulator will be presented and discussed. Field results will be presented that demonstrate the effectiveness of polished cutters, in both water and oil-based muds. Increases in penetration rates of 300-400% have been observed in the Wilcox formation and other highly pressured shales. Typically, the beneficial effects of polished cutters have been realized at depths greater than 7000 ft, and with mud weights exceeding 12 ppg.
- OSTI ID:
- 166602
- Report Number(s):
- CONF-951002--
- Country of Publication:
- United States
- Language:
- English
Similar Records
Proper nozzle location, bit profile, and cutter arrangement affect PDC-bit performance significantly
PDC Bit Testing at Sandia Reveals Influence of Chatter in Hard-Rock Drilling