UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence X - Raw Data
- Pacific Northwest National Laboratory
Sequence X: Elevated RPM (F) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 12 m/s, and yaw angles of ±30° were obtained. The blade pitch angle was 3°. The rotor rotated at 90 RPM. Blade pressure measurements were collected. The five-hole probes were removed and the plugs were installed. Plastic tape 0.03-mm-thick was used to smooth the interface between the plugs and the blade. The teeter dampers were replaced with rigid links, and these two channels were flagged as not applicable by setting the measured values in the data file to –99999.99 Nm. The teeter link load cell was pre-tensioned to 40,000 N. During post-processing, the probe channels were set to read -99999.99. As described in Appendix F, the hydrostatic correction derived for operation at 72 RPM was applied to these data.
- Research Organization:
- Atmosphere to Electrons (A2e) Data Archive and Portal, Pacific Northwest National Laboratory; PNNL
- Sponsoring Organization:
- USDOE Office of Energy Efficiency and Renewable Energy (EERE), Wind and Water Technologies Office (EE-4W)
- OSTI ID:
- 1483944
- Country of Publication:
- United States
- Language:
- English
Similar Records
UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence T - Raw Data
UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence U - Raw Data