An Alternative Low-Cost Process for Deposition of MCrAlY Bond Coats for Advanced Syngas/Hydrogen Turbine Applications
- Tennessee Technological Univ., Cookeville, TN (United States)
The objective of this project was to develop and optimize MCrAlY bond coats for syngas/hydrogen turbine applications using a low-cost electrolytic codeposition process. Prealloyed CrAlY-based powders were codeposited into a metal matrix of Ni, Co or Ni-Co during the electroplating process, and a subsequent post-deposition heat treatment converted it to the MCrAlY coating. Our research efforts focused on: (1) investigation of the effects of electro-codeposition configuration and parameters on the CrAlY particle incorporation in the NiCo-CrAlY composite coatings; (2) development of the post-deposition heat treating procedure; (3) characterization of coating properties and evaluation of coating oxidation performance; (4) exploration of a sulfurfree electroplating solution; (5) cost analysis of the present electrolytic codeposition process. Different electro-codeposition configurations were investigated, and the rotating barrel system demonstrated the capability of depositing NiCo-CrAlY composite coatings uniformly on the entire specimen surface, with the CrAlY particle incorporation in the range 37-42 vol.%. Post-deposition heat treatment at 1000-1200 °C promoted interdiffusion between the CrAlY particles and the Ni-Co metal matrix, resulting in β/γ’/γ or β/γ’ phases in the heat-treated coatings. The results also indicate that the post-deposition heat treatment should be conducted at temperatures ≤1100 °C to minimize Cr evaporation and outward diffusion of Ti. The electro-codeposited NiCrAlY coatings in general showed lower hardness and surface roughness than thermal spray MCrAlY coatings. Coating oxidation performance was evaluated at 1000-1100 °C in dry and wet air environments. The initial electro-codeposited NiCoCrAlY coatings containing relatively high sulfur did not show good oxidation resistance. After modifications of the coating process, the cleaner NiCoCrAlY coating exhibited good oxidation performance at 1000 °C during the 2,000 1-h cyclic oxidation test. A sulfur-free fluoboratebased plating solution was explored in order to reduce the sulfur level in the electro-codeposited MCrAlY coatings. However, chemical reactions occurred between the CrAlY powder and the fluoborate plating solution, resulting in dark powdery coatings. The fluoborate-based plating bath can thus only be used to codeposit more inert particles (e.g., oxides or carbides) instead of the present Al-containing metallic particles.
- Research Organization:
- Tennessee Technological Univ., Cookeville, TN (United States)
- Sponsoring Organization:
- USDOE
- DOE Contract Number:
- FE0007332
- OSTI ID:
- 1253139
- Country of Publication:
- United States
- Language:
- English
Similar Records
Development of Corrosion- and Erosion-Resistant Coatings for Advanced Ultra-Supercritical Materials
Aluminide Coatings for Power-Generation Applications