Heat Exchanger Support Bracket Design Calculations
- Fermi National Accelerator Laboratory (FNAL), Batavia, IL (United States)
This engineering note documents the design of the heat exchanger support brackets. The heat exchanger is roughly 40 feet long, 22 inches in diameter and weighs 6750 pounds. It will be mounted on two identical support brackets that are anchored to a concrete wall. The design calculations were done for one bracket supporting the full weight of the heat exchanger, rounded up to 6800 pounds. The design follows the American Institute of Steel Construction (AISC) Manual of steel construction, Eighth edition. All calculated stresses and loads on welds were below allowables.
- Research Organization:
- Fermi National Accelerator Laboratory (FNAL), Batavia, IL
- Sponsoring Organization:
- USDOE
- DOE Contract Number:
- AC02-07CH11359
- OSTI ID:
- 1033314
- Report Number(s):
- FERMILAB-D0-EN--417
- Country of Publication:
- United States
- Language:
- English
Similar Records
LAB 3 Cleanroom Fan and Filters Analysis for the Supports
Design and performance evaluation of legal weight truck tractor and prototype semitrailer for the highway transport of spent nuclear fuel
Guidelines for structural bolting in accordance with the AISC (American Institute of Steel Construction) ninth edition Manual of Steel Construction''
Technical Report
·
Fri May 08 00:00:00 EDT 1998
·
OSTI ID:1032108
Design and performance evaluation of legal weight truck tractor and prototype semitrailer for the highway transport of spent nuclear fuel
Conference
·
Sat Dec 30 23:00:00 EST 1995
·
OSTI ID:225364
Guidelines for structural bolting in accordance with the AISC (American Institute of Steel Construction) ninth edition Manual of Steel Construction''
Technical Report
·
Wed Jun 06 00:00:00 EDT 1990
·
OSTI ID:6782645