Installation and initial operation of the DIII-D advanced divertor cryocondensation pump

Conference · Fri Oct 01 04:00:00 EDT 1993

OSTI ID:10190778

Smith, J P; Schaubel, K M; Baxi, C B; Campbell, G L; Hyatt, A W; Laughon, G J; Mahdavi, M A; Reis, E E; Schaffer, M J; Sevier, D L; Stambaugh, R D ^[1]; Menon, M M ^[2]

---

1. General Atomics, San Diego, CA (United States)
2. Oak Ridge National Lab., TN (United States)

Phase two of a divertor cryocondensation pump, the Advanced Divertor Program, is now installed in the DIII-D tokamak at General Atomics and complements the phase one biasable ring electrode. The installation consists of a 10 m long cryocondensation pump located in the divertor baffle chamber to study plasma density control by pumping of the divertor. The design is a toroidally electrically continuous liquid helium-cooled panel with 1 m{sup 2} of pumping surface. The helium panel is single point grounded to the nitrogen shield to minimize eddy currents. The nitrogen shield is toroidally continuous and grounded to the vacuum vessel in 24 locations to prevent voltage potentials from building up between the pump and vacuum vessel wall. A radiation/particle shield surrounds the nitrogen-cooled surface to minimize the heat load and prevent water molecules condensed on the nitrogen surface from being released by impact of energetic particles. Large currents (>5000 A) are driven in the helium and nitrogen panels during ohmic coil ramp up and during disruptions. The pump is designed to accommodate both the thermal and mechanical loads due to these currents. A feedthrough for the cryogens allows for both radial and vertical motion of the pump with respect to the vacuum vessel. Thermal performance measured on a prototype verified the analytical model and thermal design of the pump. Characterization tests of the installed pump show the pumping speed in deuterium is 42,000 {ell}/sec for a pressure of 5 mTorr. Induction heating of the pump (at 300 W) resulted in no degradation of pumping speed. Plasma operations with the cryopump show a 60% lower density in H-mode.

• Research Organization: General Atomics, San Diego, CA (United States); Oak Ridge National Lab., TN (United States)
• Sponsoring Organization: USDOE, Washington, DC (United States)
• DOE Contract Number: AC03-89ER51114; AC05-84OR21400
• OSTI ID: 10190778
• Report Number(s): GA-A--21396; CONF-931018--20; ON: DE94001106
• Country of Publication: United States
• Language: English

Related Subjects

70 PLASMA PHYSICS AND FUSION TECHNOLOGY
700420
CRYOPUMPS
DESIGN
DOUBLET-3 DEVICE
EDDY CURRENTS
HEAT FLUX
INDUCTION
PERFORMANCE TESTING
PLASMA DENSITY
PLASMA-FACING COMPONENTS
PUMPED LIMITERS