Practical hot oiling and hot watering for paraffin control

Conference · Tue Mar 01 04:00:00 EST 1994

OSTI ID:10127994

Mansure, A J ^[1]; Barker, K M ^[2]

---

1. Sandia National Labs., Albuquerque, NM (United States)
2. Petrolite Corp. (United States)

One of the common oil-field wellbore problems is paraffin deposition. Even though hot oiling or hot watering is usually the first method tried for removing paraffin, few operators appreciate the limitations of ``hot oiling`` and the potential for the fluid to aggravate well problems and cause formation damage. Field tests have shown that the chemical and thermal processes that occur during ``hot oiling`` are very complex and that there are significant variations in practices among operators. Key issues include: (1) During a typical hot oiling job, a significant amount of the fluid injected into the well goes into the formation, and hence, particulates and chemicals in the fluid have the potential to damage the formation. (2) Hot oiling can vaporize oil in the tubing faster than the pump lifts oil. This interrupts paraffin removal from the well, and thus the wax is refined into harder deposits, goes deeper into the well, and can stick rods. These insights have been used to determine good ``hot oiling`` practices designed to maximize wax removal and minimize formation damage.

• Research Organization: Sandia National Labs., Albuquerque, NM (United States)
• Sponsoring Organization: USDOE, Washington, DC (United States)
• DOE Contract Number: AC04-94AL85000
• OSTI ID: 10127994
• Report Number(s): SAND--94-0390C; CONF-9404111--1; CONF-9303259--1; ON: DE94007302; BR: GB0103012
• Country of Publication: United States
• Language: English

Related Subjects

02 PETROLEUM
020300
DEWAXING
DRILLING AND PRODUCTION
OIL WELLS
PARAFFIN
REMOVAL