Tensile properties, strain rate sensitivity, and activation volume of additively manufactured 316L stainless steels [Tensile properties of 316L stainless steels made by laser powder-bed-fusion additive manufacturing]
- Lawrence Livermore National Lab. (LLNL), Livermore, CA (United States)
The tensile properties of additively manufactured (AM) metals and alloys are among the most important variables that impact the potential applications of these materials. Here we examine and report on the tensile properties of AM 316L stainless steels fabricated by the laser powder-bed-fusion (L-PBF) technique, via twelve sets of optimized laser processing parameters that produce materials with density >98.8 ± 0.10%. A heterogeneous microstructure is observed in all L-PBF samples, including microscopic features such as dislocations, cellular walls, elemental segregations, local misorientations, impurities, precipitates, and a large fraction of low-angle grain boundaries (2-10°, ~40–60%). The derived average grain size defined by high-angle grain boundaries (>10°) is ~30–50 μm. Tensile testing reveals a yield strength ranging from 552 to 635 MPa and a tensile-elongation-to-failure (TEF) of 0.09–0.42 for directly-printed samples, whereas these values are 592–690 MPa and 0.29–0.50 for samples machined from the as-built rectangular thin plates. In all samples, we observe a variation of tensile yield strength within ~15% but not the TEF, suggesting marginal microstructural changes despite a wide range of laser processing parameters. The large scatter of TEF in directly-printed samples originates from the sensitivity of thin gauge geometry (~2 mm2 cross-section area) to the built-in flaws. We measured a substantially higher strain rate sensitivity (m~0.02–0.03) of L-PBF 316L compared to the coarse-grained counterparts (~0.006), together with a small activation volume of ~20–30b3 (where b is the Burgers vector of 316L). In conclusion, these deformation kinetics parameters suggest that the tensile plasticity of L-PBF 316L is controlled by a much finer microstructural length scale than the measured grain size, consistent with the high strength and juxtaposed nano- to macro-structures seen in these materials. Strategies to optimize the tensile properties of AM materials are discussed.
- Research Organization:
- Lawrence Livermore National Lab. (LLNL), Livermore, CA (United States)
- Sponsoring Organization:
- USDOE National Nuclear Security Administration (NNSA)
- Grant/Contract Number:
- AC52-07NA27344
- OSTI ID:
- 1566789
- Report Number(s):
- LLNL-JRNL-706341; 841230
- Journal Information:
- International Journal of Plasticity, Vol. 120, Issue C; ISSN 0749-6419
- Publisher:
- ElsevierCopyright Statement
- Country of Publication:
- United States
- Language:
- English
Web of Science
Similar Records
Mechanical Properties of Additively Manufactured 316L Stainless Steel Before and After Neutron Irradiation–FY23
Mechanical Properties and Deformation Behavior of Additively Manufactured 316L Stainless Steel (FY2020)