The RHIC injection kicker
Beam transfer from the AGS to RHIC is performed in single-bunch mode. Close spacing of the bunches in the collider requires an injection kicker with a rise time of <90 nsec, suggesting adoption of a travelling wave structure. The required vertical kick of 0.186 t{center_dot}m is provided by 4 magnets, each 1.12 m long with a 48.4 x 48.4 mm aperture and operated at 1.6 kA. The kicker is constructed as a {open_quotes}C{close_quotes} cross section magnet, in which ferrite and high-permittivity dielectric sections alternate. The dielectric blocks provide the capacity necessary for the nominally 25 {Omega} characteristic impedance of the travelling wave structure, but impose the practical limit on the peak voltage, and thus current, achievable. Computer studies to minimize local electric field enhancements resulted in a configuration capable of holding {approximately} 50 kV, with adequate safety margin over the nominal 40 kV. Equivalent circuit analysis indicated the possibility of lowering the nominal voltage by operating mismatched into 20 {Omega} terminations without degrading the pulse shape. In this paper, the experience gained in the fabrication of the production units and the results from various single-unit tests and operation of four kickers with beam in the {open_quotes}Sextant Test{close_quotes} are reported.
- Research Organization:
- Brookhaven National Lab. (BNL), Upton, NY (United States)
- Sponsoring Organization:
- USDOE Office of Energy Research, Washington, DC (United States)
- DOE Contract Number:
- AC02-76CH00016
- OSTI ID:
- 491371
- Report Number(s):
- BNL-64023; CONF-970503-90; ON: DE97006666; TRN: 97:012670
- Resource Relation:
- Conference: 17. IEEE particle accelerator conference, Vancouver (Canada), 12-16 May 1997; Other Information: PBD: 1997
- Country of Publication:
- United States
- Language:
- English
Similar Records
The coupling impedance of the RHIC injection kicker system
ALL-FERRITE RHIC INJECTION KICKER