Tensile and Microstructure Characterization of SNS Target Swirl Bubblers Fabricated by Additive Manufacturing
During operation the mercury facing surfaces of the Spallation Neutron Source target vessel are damaged by cavitation-induced erosion. One option to decrease the erosion damage to the SNS target vessel surfaces is to decrease the intensity of the pressure waves using small bubble mitigation. Injection of small diameter helium bubbles into mercury has been shown in decrease the intensity of proton-induced pressure waves and mitigate erosion damage to mercury/container interface surfaces. Several bubbler designs have been evaluated for implementation in the SNS target. One promising bubbler design is called a swirl bubbler, which is capable of producing a high density of very small diameter helium bubbles in flowing mercury. Due to the complexity of the swirl bubbler design and the geometric restrictions of conventional machining processes, additive manufacturing was considered for fabrication. But there was uncertainty with the mechanical properties of bubblers fabricated with additive manufacturing. A series of experiments were designed to characterize the tensile properties and microstructure of swirl bubblers fabricated using selective laser melting (SLM), both before and after consolidation via hot isostatic pressing (HIPing). This report summarizes the tensile and microstructural characterization of HIPed and non-HIPed swirl bubblers produced via the SLM process. The results show that the as-fabricated material contained appreciable porosity, lack-of-fusion defects, and inconsistent tensile properties with essentially zero ductility. But after a HIPing treatment the microstructure became fully consolidated, and the tensile properties surpassed the requirements specified in the material standard for steel-mill produced 316L plate material used to fabricate the SNS target vessel. While further testing is recommended to evaluate the material’s susceptibility to fatigue fracture, these results indicate 316L bubbler assemblies produced SLM and HIPed are promising candidates for implementation in a future SNS target module.
- Research Organization:
- Oak Ridge National Laboratory (ORNL), Oak Ridge, TN (United States)
- Sponsoring Organization:
- USDOE
- DOE Contract Number:
- AC05-00OR22725
- OSTI ID:
- 1479726
- Report Number(s):
- ORNL/TM-2018/1029
- Country of Publication:
- United States
- Language:
- English
Similar Records
Bubble Generation in the SNS 2 MW Mercury Target
Choked-Flow Inlet Orifice Bubbler for Creating Small Bubbles in Mercury