Dynamic pull-in of parallel plate and torsional electrostatic MEMS actuators.
- Massachusetts Institute of Technology, Cambridge, MA
An analysis of the dynamic characteristics of pull-in for parallel-plate and torsional electrostatic actuators is presented. Traditionally, the analysis for pull-in has been done using quasi-static assumptions. However, it was recently shown experimentally that a step input can cause a decrease in the voltage required for pull-in to occur. We propose an energy-based solution for the step voltage required for pull-in that predicts the experimentally observed decrease in the pull-in voltage. We then use similar energy techniques to explore pull-in due to an actuation signal that is modulated depending on the sign of the velocity of the plate (i.e., modulated at the instantaneous mechanical resonant frequency). For this type of actuation signal, significant reductions in the pull-in voltage can theoretically be achieved without changing the stiffness of the structure. This analysis is significant to both parallel-plate and torsional electrostatic microelectromechanical systems (MEMS) switching structures where a reduced operating voltage without sacrificing stiffness is desired, as well as electrostatic MEMS oscillators where pull-in due to dynamic effects needs to be avoided.
- Research Organization:
- Sandia National Laboratories (SNL), Albuquerque, NM, and Livermore, CA (United States)
- Sponsoring Organization:
- USDOE
- DOE Contract Number:
- AC04-94AL85000
- OSTI ID:
- 990971
- Report Number(s):
- SAND2005-0863J; TRN: US201020%%643
- Journal Information:
- Proposed for publication in Journal of Microelectromechanical Systems., Vol. 15, Issue 4; ISSN 1057-7157
- Country of Publication:
- United States
- Language:
- English
Similar Records
Amorphous Diamond MEMS and Sensors
Modeling, simulation, and testing of the mechanical dynamics of and RF MEMS switch.