skip to main content

SciTech ConnectSciTech Connect

Title: The influence of alloy composition on residual stresses in heat treated aluminium alloys

The as quenched properties of eight different heat treatable aluminium alloys are related to residual stress magnitudes with the objective being to establish if there is a relationship between the residual stress and the as quenched alloy hardness and strength. Near surface residual stresses were assessed with X-ray diffraction using both the established sin{sup 2}ψ method and the more recent cos α technique. Through thickness residual stresses were also characterised using neutron diffraction. The alloys were chosen to encompass a wide range of strengths. The low to medium strength alloys were 6060 and 6082, medium to high strength 2618A, 2014A, 7075, 7010 and two variants of 7449, while the very high strength alloy was the powder metallurgy alloy N707. To assess the as quenched strength, dynamic hardness and tensile properties were determined from samples tested immediately after quenching to minimise the influence of precipitation hardening by natural aging. In addition, hot hardness measurements were made in situ on samples cooled to simulate quench paths. Within the experimental constraints of the investigation, the distribution of residual stress through the thickness was found to follow the same pattern for all the alloys investigated, varying from tensile in the interior to surface compression.more » The influence of alloy strength was manifested as a change in the observed residual stress magnitudes, and surface residual stresses were found to vary linearly with as quenched hardness and strength. - Highlights: • As quenched aluminium alloys contain high magnitude residual stresses. • Surface is compressive balance by a tensile core. • As quenched surface residual stress is linear function of alloy strength. • In situ hot hardness demonstrates rapid change in intrinsic hardness during rapid cooling.« less
Authors:
 [1] ;  [2]
  1. Department of Mechanical, Aeronautical and Biomedical Engineering, University of Limerick (Ireland)
  2. Materials and Surface Science Institute, University of Limerick (Ireland)
Publication Date:
OSTI Identifier:
22476110
Resource Type:
Journal Article
Resource Relation:
Journal Name: Materials Characterization; Journal Volume: 105; Other Information: Copyright (c) 2015 Elsevier Science B.V., Amsterdam, The Netherlands, All rights reserved.; Country of input: International Atomic Energy Agency (IAEA)
Country of Publication:
United States
Language:
English
Subject:
36 MATERIALS SCIENCE; ALUMINIUM ALLOYS; COOLING; DISTRIBUTION; HARDNESS; HEAT TREATMENTS; LIMITING VALUES; NEUTRON DIFFRACTION; NEUTRONS; POWDER METALLURGY; PRECIPITATION HARDENING; RESIDUAL STRESSES; SURFACES; TENSILE PROPERTIES; THICKNESS; X-RAY DIFFRACTION