Introduction of DC line structures into a superconducting microwave 3D cavity

Journal Article · Sun Feb 15 00:00:00 EST 2015 · Review of Scientific Instruments

DOI:https://doi.org/10.1063/1.4913252· OSTI ID:22392349

Kong, Wei-Cheng; Deng, Guang-Wei; Li, Shu-Xiao; Li, Hai-Ou; Cao, Gang; Xiao, Ming; Guo, Guo-Ping ^[1]

---

1. Key Laboratory of Quantum Information, University of Science and Technology of China, Chinese Academy of Sciences, Hefei 230026, China and Synergetic Innovation Center of Quantum Information and Quantum Physics, University of Science and Technology of China, Hefei, Anhui 230026 (China)

We report a technique that can noninvasively add multiple DC wires into a 3D superconducting microwave cavity for electronic devices that require DC electrical terminals. We studied the influence of our DC lines on the cavity performance systematically. We found that the quality factor of the cavity is reduced if any of the components of the electrical wires cross the cavity equipotential planes. Using this technique, we were able to incorporate a quantum dot (QD) device into a 3D cavity. We then controlled and measured the QD transport signal using the DC lines. We have also studied the heating effects of the QD by the microwave photons in the cavity.

• OSTI ID: 22392349
• Journal Information: Review of Scientific Instruments, Vol. 86, Issue 2; Other Information: (c) 2015 AIP Publishing LLC; Country of input: International Atomic Energy Agency (IAEA); ISSN 0034-6748
• Country of Publication: United States
• Language: English

Related Subjects

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND TECHNOLOGY
ELECTRONIC EQUIPMENT
HEATING
MICROWAVE RADIATION
PERFORMANCE
PHOTONS
QUALITY FACTOR
QUANTUM DOTS
SIGNALS
SUPERCONDUCTING CAVITY RESONATORS
WIRES