The inverse problems of wing panel manufacture processes
- Komsomolsk-on-Amur State Technical University, Lenina prospect 27, Komsomolsk-on-Amur, 681013, Russian Federation, and Institute of Machinery and Metallurgy Far Eastern Branch of the Russian Academy of Sciences, Metallurgov Street 1, Komsomolsk-on-Am (Russian Federation)
- Komsomolsk-on-Amur State Technical University, Lenina prospect 27, Komsomolsk-on-Amur, 681013, Russian Federation (Russian Federation)
It is shown that inverse problems of steady-state creep bending of plates in both the geometrically linear and nonlinear formulations can be represented in a variational formulation. Steady-state values of the obtained functionals corresponding to the solutions of the problems of inelastic deformation and springback are determined by applying a finite element procedure to the functionals. Optimal laws of creep deformation are formulated using the criterion of minimizing damage in the functionals of the inverse problems. The formulated problems are reduced to the problems solved by the finite element method using MSC.Marc software. Currently, forming of light metals poses tremendous challenges due to their low ductility at room temperature and their unusual deformation characteristics at hot-cold work: strong asymmetry between tensile and compressive behavior, and a very pronounced anisotropy. We used the constitutive models of steady-state creep of initially transverse isotropy structural materials the kind of the stress state has influence. The paper gives basics of the developed computer-aided system of design, modeling, and electronic simulation targeting the processes of manufacture of wing integral panels. The modeling results can be used to calculate the die tooling, determine the panel processibility, and control panel rejection in the course of forming.
- OSTI ID:
- 22261652
- Journal Information:
- AIP Conference Proceedings, Vol. 1567, Issue 1; Conference: NUMISHEET 2014: 9. international conference and workshop on numerical simulation of 3D sheet metal forming processes, Melbourne (Australia), 6-10 Jan 2014; Other Information: (c) 2013 AIP Publishing LLC; Country of input: International Atomic Energy Agency (IAEA); ISSN 0094-243X
- Country of Publication:
- United States
- Language:
- English
Similar Records
Springback Prediction on Slit-Ring Test
Springback Prediction, Compensation and Correlation for Automotive Stamping