Monte Carlo simulation of a novel water-equivalent electronic portal imaging device using plastic scintillating fibers
- Imaging Research, Sunnybrook Health Sciences Centre, Department of Medical Biophysics, University of Toronto, Toronto M4N 3M5 (Canada)
Purpose: Most electronic portal imaging devices (EPIDs) developed so far use a thin Cu plate/phosphor screen to convert x-ray energies into light photons, while maintaining a high spatial resolution. This results in a low x-ray absorption and thus a low quantum efficiency (QE) of approximately 2-4% for megavoltage (MV) x-rays. A significant increase of QE is desirable for applications such as MV cone-beam computed tomography (MV-CBCT). Furthermore, the Cu plate/phosphor screen contains high atomic number (high-Z) materials, resulting in an undesirable over-response to low energy x-rays (due to photoelectric effect) as well as high energy x-rays (due to pair production) when used for dosimetric verification. Our goal is to develop a new MV x-ray detector that has a high QE and uses low-Z materials to overcome the obstacles faced by current MV x-ray imaging technologies. Methods: A new high QE and low-Z EPID is proposed. It consists of a matrix of plastic scintillating fibers embedded in a water-equivalent medium and coupled to an optically sensitive 2D active matrix flat panel imager (AMFPI) for image readout. It differs from the previous approach that uses segmented crystalline scintillators made of higher density and higher atomic number materials to detect MV x-rays. The plastic scintillating fibers are focused toward the x-ray source to avoid image blurring due to oblique incidence of off-axis x-rays. When MV x-rays interact with the scintillating fibers in the detector, scintillation light will be produced. The light photons produced in a fiber core and emitted within the acceptance angle of the fiber will be guided toward the AMFPI by total internal reflection. A Monte Carlo simulation has been used to investigate imaging and dosimetric characteristics of the proposed detector under irradiation of MV x-rays. Results: Properties, such as detection efficiency, modulation transfer function, detective quantum efficiency (DQE), energy dependence of detector response, and water-equivalence of dose response have been investigated. It has been found that the zero frequency DQE of the proposed detector can be up to 37% at 6 MV. The detector, also, is water-equivalent with a relatively uniform response to different energy x-rays as compared to current EPIDs. Conclusions: The results of our simulations show that, using plastic scintillating fibers, it is possible to construct a water-equivalent EPID that has a better energy response and a higher detection efficiency than current flat panel based EPIDs.
- OSTI ID:
- 22098789
- Journal Information:
- Medical Physics, Vol. 39, Issue 3; Other Information: (c) 2012 American Association of Physicists in Medicine; Country of input: International Atomic Energy Agency (IAEA); ISSN 0094-2405
- Country of Publication:
- United States
- Language:
- English
Similar Records
Segmented crystalline scintillators: An initial investigation of high quantum efficiency detectors for megavoltage x-ray imaging
Monte Carlo simulation of a quantum noise limited Čerenkov detector based on air-spaced light guiding taper for megavoltage x-ray imaging
Related Subjects
62 RADIOLOGY AND NUCLEAR MEDICINE
ATOMIC NUMBER
COMPUTERIZED SIMULATION
COMPUTERIZED TOMOGRAPHY
DETECTION
DOSIMETRY
ENERGY DEPENDENCE
MONTE CARLO METHOD
PAIR PRODUCTION
PHOSPHORS
PHOTOELECTRIC EFFECT
PLASTIC SCINTILLATION DETECTORS
QUANTUM EFFICIENCY
RADIATION DOSES
READOUT SYSTEMS
SPATIAL RESOLUTION
TRANSFER FUNCTIONS
X RADIATION
X-RAY SOURCES