skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Properties of Oxygenates Found in Upgraded Biomass Pyrolysis Oil as Components of Spark and Compression Ignition Engine Fuels

Abstract

We examined xxygenates present in partially hydroprocessed lignocellulosic-biomass pyrolysis oils for their impact on the performance properties of gasoline and diesel. These included: methyltetrahydrofuran, 2,5-dimethylfuran (DMF), 2-hexanone, 4-methylanisole, phenol, p-cresol, 2,4-xylenol, guaiacol, 4-methylguaiacol, 4-methylacetophenone, 4-propylphenol, and 4-propylguaiacol. Literature values indicate that acute toxicity for these compounds falls within the range of the components in petroleum-derived fuels. On the basis of the available data, 4-methylanisole and by extension other methyl aryl ethers appear to be the best drop-in fuel components for gasoline because they significantly increase research octane number and slightly reduce vapor pressure without significant negative fuel property effects. A significant finding is that DMF can produce high levels of gum under oxidizing conditions. If the poor stability results observed for DMF could be addressed with a stabilizer additive or removal of impurities, it could also be considered a strong drop-in fuel candidate. The low solubility of phenol and p-cresol (and by extension, the two other cresol isomers) in hydrocarbons and the observation that phenol is also highly extractable into water suggest that these molecules cannot likely be present above trace levels in drop-in fuels. The diesel boiling range oxygenates all have low cetane numbers, which presents challenges for blendingmore » into diesel fuel. Moreover, there were some beneficial properties observed for the phenolic oxygenates in diesel, including increasing conductivity, lubricity, and oxidation stability of the diesel fuel. Oxygenates other than phenol and cresol, including other phenolic compounds, showed no negative impacts at the low blend levels examined here and could likely be present in an upgraded bio-oil gasoline or diesel blendstock at low levels to make a drop-in fuel. On the basis of solubility parameter theory, 4-methylanisole and DMF showed less interaction with elastomers than ethanol, while phenolic compounds showed somewhat greater interaction. This effect is not large, especially at low blend levels, and is also less significant as the size and number of alkyl substituents on the phenol ring increase.« less

Authors:
 [1];  [1];  [1];  [1];  [1];  [1];  [2];  [3];  [3]
  1. National Renewable Energy Laboratory, Golden, Colorado 80401, United States
  2. EcoEngineering, Inc., Boulder, Colorado 80304, United States
  3. Eindhoven Technical University, 5612AZ Eindhoven, Netherlands
Publication Date:
Research Org.:
National Renewable Energy Laboratory (NREL), Golden, CO (United States)
Sponsoring Org.:
USDOE Office of Energy Efficiency and Renewable Energy (EERE), Office of Sustainable Transportation. Vehicle Technologies Office (VTO); USDOE Office of Energy Efficiency and Renewable Energy (EERE), Vehicle Technologies Office (EE-3V)
OSTI Identifier:
1178174
Alternate Identifier(s):
OSTI ID: 1220653
Report Number(s):
NREL/JA-5400-63352
Journal ID: ISSN 0887-0624
Grant/Contract Number:  
FOA-0000239; DE347AC36-99GO10337; AC36-08GO28308; 347-AC36-99GO10337
Resource Type:
Journal Article: Published Article
Journal Name:
Energy and Fuels
Additional Journal Information:
Journal Name: Energy and Fuels Journal Volume: 29 Journal Issue: 4; Journal ID: ISSN 0887-0624
Publisher:
American Chemical Society
Country of Publication:
United States
Language:
English
Subject:
09 BIOMASS FUELS; biomass; pyrolysis; oxygenates; gasoline; diesel

Citation Formats

McCormick, Robert L., Ratcliff, Matthew A., Christensen, Earl, Fouts, Lisa, Luecke, Jon, Chupka, Gina M., Yanowitz, Janet, Tian, Miao, and Boot, Michael. Properties of Oxygenates Found in Upgraded Biomass Pyrolysis Oil as Components of Spark and Compression Ignition Engine Fuels. United States: N. p., 2015. Web. doi:10.1021/ef502893g.
McCormick, Robert L., Ratcliff, Matthew A., Christensen, Earl, Fouts, Lisa, Luecke, Jon, Chupka, Gina M., Yanowitz, Janet, Tian, Miao, & Boot, Michael. Properties of Oxygenates Found in Upgraded Biomass Pyrolysis Oil as Components of Spark and Compression Ignition Engine Fuels. United States. https://doi.org/10.1021/ef502893g
McCormick, Robert L., Ratcliff, Matthew A., Christensen, Earl, Fouts, Lisa, Luecke, Jon, Chupka, Gina M., Yanowitz, Janet, Tian, Miao, and Boot, Michael. 2015. "Properties of Oxygenates Found in Upgraded Biomass Pyrolysis Oil as Components of Spark and Compression Ignition Engine Fuels". United States. https://doi.org/10.1021/ef502893g.
@article{osti_1178174,
title = {Properties of Oxygenates Found in Upgraded Biomass Pyrolysis Oil as Components of Spark and Compression Ignition Engine Fuels},
author = {McCormick, Robert L. and Ratcliff, Matthew A. and Christensen, Earl and Fouts, Lisa and Luecke, Jon and Chupka, Gina M. and Yanowitz, Janet and Tian, Miao and Boot, Michael},
abstractNote = {We examined xxygenates present in partially hydroprocessed lignocellulosic-biomass pyrolysis oils for their impact on the performance properties of gasoline and diesel. These included: methyltetrahydrofuran, 2,5-dimethylfuran (DMF), 2-hexanone, 4-methylanisole, phenol, p-cresol, 2,4-xylenol, guaiacol, 4-methylguaiacol, 4-methylacetophenone, 4-propylphenol, and 4-propylguaiacol. Literature values indicate that acute toxicity for these compounds falls within the range of the components in petroleum-derived fuels. On the basis of the available data, 4-methylanisole and by extension other methyl aryl ethers appear to be the best drop-in fuel components for gasoline because they significantly increase research octane number and slightly reduce vapor pressure without significant negative fuel property effects. A significant finding is that DMF can produce high levels of gum under oxidizing conditions. If the poor stability results observed for DMF could be addressed with a stabilizer additive or removal of impurities, it could also be considered a strong drop-in fuel candidate. The low solubility of phenol and p-cresol (and by extension, the two other cresol isomers) in hydrocarbons and the observation that phenol is also highly extractable into water suggest that these molecules cannot likely be present above trace levels in drop-in fuels. The diesel boiling range oxygenates all have low cetane numbers, which presents challenges for blending into diesel fuel. Moreover, there were some beneficial properties observed for the phenolic oxygenates in diesel, including increasing conductivity, lubricity, and oxidation stability of the diesel fuel. Oxygenates other than phenol and cresol, including other phenolic compounds, showed no negative impacts at the low blend levels examined here and could likely be present in an upgraded bio-oil gasoline or diesel blendstock at low levels to make a drop-in fuel. On the basis of solubility parameter theory, 4-methylanisole and DMF showed less interaction with elastomers than ethanol, while phenolic compounds showed somewhat greater interaction. This effect is not large, especially at low blend levels, and is also less significant as the size and number of alkyl substituents on the phenol ring increase.},
doi = {10.1021/ef502893g},
url = {https://www.osti.gov/biblio/1178174}, journal = {Energy and Fuels},
issn = {0887-0624},
number = 4,
volume = 29,
place = {United States},
year = {Thu Mar 19 00:00:00 EDT 2015},
month = {Thu Mar 19 00:00:00 EDT 2015}
}

Journal Article:
Free Publicly Available Full Text
Publisher's Version of Record at https://doi.org/10.1021/ef502893g

Citation Metrics:
Cited by: 70 works
Citation information provided by
Web of Science

Save / Share:

Works referenced in this record:

The flash pyrolysis of aspen-poplar wood
journal, October 1982


A review and perspective of recent bio-oil hydrotreating research
journal, January 2014


Renewable Oxygenate Blending Effects on Gasoline Properties
journal, October 2011


Bio-oil Stabilization and Upgrading by Hot Gas Filtration
journal, May 2013


Pyrolysis of Wood/Biomass for Bio-oil: A Critical Review
journal, May 2006


Performance of lignin derived aromatic oxygenates in a heavy-duty diesel engine
journal, January 2014


Prediction of Hansen Solubility Parameters with a New Group-Contribution Method
journal, April 2008


Fuel Oil Quality of Biomass Pyrolysis OilsState of the Art for the End Users
journal, July 1999


Solubility and Equilibrium Data of Phenol-Water-n-Butyl Acetate System at 30° C.
journal, July 1962


Selective O-Alkylation of Phenol with Methanol over Sulfates Supported on γ-Al2O3
journal, March 1995


Real-Time Viscosity Measurements during the Accelerated Aging of Biomass Pyrolysis Oil
journal, July 2011


Recent Advances in Hydrotreating of Pyrolysis Bio-Oil and Its Oxygen-Containing Model Compounds
journal, April 2013


Anisole production by alkylation of phenol over ZSM5
journal, October 1986


Ignition characteristics of a bio-derived class of saturated and unsaturated furans for engine applications
journal, January 2015


A perspective on oxygenated species in the refinery integration of pyrolysis oil
journal, January 2014


Utilization of Renewable Oxygenates as Gasoline Blending Components
report, August 2011


Air-Water Partitioning and Aqueous Solubility of Phenols
journal, March 1995


Analysis of Oxygenated Compounds in Hydrotreated Biomass Fast Pyrolysis Oil Distillate Fractions
journal, November 2011


Combustion and Emissions of 2,5-Dimethylfuran in a Direct-Injection Spark-Ignition Engine
journal, May 2010


Experimental Study of Biomass Pyrolysis Based on Three Major Components: Hemicellulose, Cellulose, and Lignin
journal, September 2011


Additives To Lower and Stabilize the Viscosity of Pyrolysis Oils during Storage
journal, September 1997


Overview of Applications of Biomass Fast Pyrolysis Oil
journal, March 2004


Mild Hydrotreating of Bio-Oil: Effect of Reaction Severity and Fate of Oxygenated Species
journal, July 2011