DOE PAGES title logo U.S. Department of Energy
Office of Scientific and Technical Information
  1. Influence of temperature, oxygen partial pressure, and microstructure on the high-temperature oxidation behavior of the SiC Layer of TRISO particles

    Tristructural isotropic (TRISO)-coated fuel particles are designed for use in high-temperature gas-cooled nuclear reactors, featuring a structural SiC layer that may be exposed to oxygen-rich environments over 1000 °C. Surrogate TRISO particles were tested in 0.2–20 kPa O2 atmospheres to observe the differences in oxidation behavior. Oxide growth mechanisms remained consistent from 1200–1600 °C for each PO$$_2$$, with activation energies of 228 ± 7 kJ/mol for 20 kPa O2 and 188 ± 8 kJ/mol for 0.2 kPa O2. At 1600 °C, kinetic analysis revealed a change in oxide growth mechanisms between 0.2 and 6 kPa O2. In 0.2 kPa O2,more » oxidation produced raised oxide nodules on pockets with nanocrystalline SiC. Oxidation mechanisms were determined using Atom probe tomography. Active SiC oxidation occurred in C-rich grain boundaries with low PO$$_2$$, leading to SiO2 buildup in porous nodules. Here, this phenomenon was not observed at any temperature in 20 kPa O2 environments.« less
  2. Atomically Dispersed Ni-N-C Catalysts for Electrochemical CO2 Reduction

    The atomic dispersion of nickel in Ni-N-C catalysts is key for the selective generation of carbon monoxide through the electrochemical carbon dioxide reduction reaction (CO2RR). Herein, the study reports a highly selective, atomically dispersed Ni1.0%-N-C catalyst with reduced Ni loading compared to previous reports. Extensive materials characterization fails to detect Ni crystalline phases, reveals the highest concentration of atomically dispersed Ni metal, and confirms the presence of the proposed Ni-Nx active site at this reduced loading. The catalyst shows excellent activity and selectivity toward CO generation, with a faradaic efficiency for CO generation (FECO) of 97% and partial current densitymore » for CO (jco) of -9.0 mA cm-2 at -0.9 V in an electrochemical H-type cell. CO2RR activity and selectivity are also studied by rotating disk electrode (RDE) measurements where transport limitations can be suppressed. It is expected that the utility of these Ni-N-C catalysts will lie with tandem CO2RR reaction schemes to multi-carbon (C2+) products.« less
  3. Continuity of Mitochondrial Budding: Insights from BS-C-1 Cells by In Situ Cryo-electron Tomography

    Mitochondrial division is a fundamental biological process essensial for cellular functionality and vitality. The prevailing hypothesis that dynamin related protein 1 (Drp1) provides principal control in mitochondrial division, in which it also involves the endoplasmic reticulum (ER) and the cytoskeleton, does not account for all the observations. Therefore. the hypothesis may be incomplete. Our previous study in HeLa cells led to a new hypothesis of mitochondrial division by budding. To follow-up our previous study, we employed in situ cryo-electron tomography to visualize mitochondrial budding in the intact healthy monkey kidney cells (BS-C-1 cells). Our findings reaffirm single and multiple mitochondrialmore » budding, consistent with our observations in HeLa cells. Notably, the budding regions vary significantly in diameter and length, which may represent different stages of budding. More interestingly, neither rings nor ring-like structures, nor the wrapping of ER tubes was observed in the budding regions, suggesting mitochondrial budding is independent from Drp1 and ER. Meanwhile, we uncovered direct interactions between mitochondria and large vesicles that are distinct from small mitochondrial-derived vesicles and extracellular mitovesicles. In conclusion, we propose that these interacting vesicles may have mitochondrial origins.« less
  4. Surface Manipulation on Pt2.2Ni(111) Nanocatalysts for Boosting Their ORR Performance in Alkaline Media

    We have previously shown that Pt–Ni alloy nano-octahedra with {111} facets exhibit outstanding electrochemical performance in the oxygen reduction reaction (ORR) in acidic media when their surfaces are finely tailored at the atomic level. Here, in this investigation, we further refine the surface structure of Pt2.2Ni octahedral nanocatalysts to improve ORR performance in a 0.1 M KOH solution using diverse surface manipulation techniques. Through systematic analysis using electrochemical CO stripping, cyclic voltammetry, and X-ray photoelectron spectroscopy, we examined the surfaces of Pt2.2Ni octahedral nanocatalysts pretreated with various methods, including etching in acetic acid or perchloric acid, and subsequent electrochemical activationmore » in an alkaline solution or an acidic solution. Among these treatments, those involving acidic media, particularly electrochemical cycling in acidic electrolytes, demonstrated significantly enhanced ORR activity in 0.1 M KOH. The latter exhibited a mass activity of 2.95 A/mgpt and a specific activity of 8.71 mA/cm2 at 0.90 V, surpassing state-of-the-art Pt/C by 12-fold and 34-fold, respectively. Furthermore, this identified nanocatalyst displayed robust stability, with negligible activity decay observed after 10,000 cycles. This study suggests that the improved ORR activity can be attributed to the Pt-rich surfaces with well-preserved {111} lattices on the surface-modified Pt–Ni nano-octahedra.« less
  5. Induced Chirality in QDs Using Thermoresponsive Elastin-like Polypeptides

    Circular dichroism (CD) spectroscopy has emerged as a potent tool for probing chiral small-molecule ligand exchange on natively achiral quantum dots (QDs). In this study, we report a novel approach to identifying QD–biomolecule interactions by inducing chirality in CdS QDs using thermoresponsive elastin-like polypeptides (ELPs) engineered with C-terminal cysteine residues. Our method is based on a versatile two-step ligand exchange process starting from monodisperse oleate-capped QDs in nonpolar media and proceeding through an easily accessed achiral glycine-capped QD intermediate. Successful conjugation of the ELPs onto the QDs is confirmed by the diagnostic CD response corresponding to the QD electronic transitionsmore » in the visible range. The resulting ELP:CdS conjugates demonstrate thermally reversible coacervation, as observed through dynamic light scattering, small-angle X-ray scattering, and electron microscopy. Furthermore, this research provides a foundation for using induced chirality in QD electronic transitions to probe QD conjugation to complex peptides and proteins, opening pathways for designing dynamic, stimuli-responsive hybrid nanomaterials.« less
  6. Influence of Dissolved Iron in Solution on MgO Hydroxylation and Carbonation

    MgO (periclase) is a promising material for direct air capture of CO2 using a mineral looping process, but it is unknown how impurities in the environment will affect the CO2 uptake and hence process economics. Here, we investigated the effects of dissolved iron on the extents of MgO hydroxylation and subsequent carbonation reactions to determine if this has a beneficial or detrimental effect. On single-crystal MgO, dissolved iron prevented hydration of MgO to Mg(OH)2 (brucite) and instead formed a shell of lepidocrocite (γ-FeOOH). This did not passivate the MgO as dissolution below the shell was observed. During hydroxylation of MgOmore » powders in the presence of dissolved iron, formation of brucite containing Fe(II) was observed. In addition, formation of nanoscale iron oxides containing Fe(III) was observed using magnetometry and Mössbauer spectroscopy. Subsequent carbonation experiments showed increased carbonation of MgO hydroxylated in the presence of iron. Our results indicate that the presence of dissolved solute impurities during hydroxylation may be beneficial for carbonation of hydroxylated MgO.« less
  7. Multi-slice electron ptychographic tomography for three-dimensional phase-contrast microscopy beyond the depth of focus limits

    Electron ptychography is a powerful computational method for atomic-resolution imaging with high contrast for weakly and strongly scattering elements. Modern algorithms coupled with fast and efficient detectors allow imaging specimens with tens of nanometers thicknesses with sub-0.5 Ångstrom lateral resolution. However, the axial resolution in these approaches is currently limited to a few nanometers, limiting their ability to solve novel atomic structures ab initio. Here, we experimentally demonstrate multi-slice ptychographic electron tomography, which allows atomic resolution three-dimensional phase-contrast imaging in a volume surpassing the depth of field limits. We reconstruct tilt-series 4D-STEM measurements of a $$\mathrm{Co_3O_4}$$ nanocube, yielding 2 Åmore » axial and 0.7 Å transverse resolution in a reconstructed volume of $$\mathrm{(18.2\,nm)^3}$$. Our results demonstrate a 13.5-fold improvement in axial resolution compared to multi-slice ptychography while retaining the atomic lateral resolution and the capability to image volumes beyond the depth of field limit. Multi-slice ptychographic electron tomography significantly expands the volume of materials accessible using high-resolution electron microscopy. We discuss further experimental and algorithmic improvements necessary to also resolve single weakly scattering atoms in 3D.« less
  8. Mechanical and electrical changes in electrochemically active polyimide binders for Li-ion batteries

    Polyimide binders are often used in electrodes made with silicon for lithium-ion batteries for their mechanical strength and adhesion, which help mitigate mechanical issues associated with large volumetric expansion. These binders can be electrochemically active, but it is difficult to characterize what physical and chemical changes occur due to a composite electrode with multiple components and processes at play. Here, in this work, we study electrodes consisting only of polyimide binder and conductive carbon, using scanning probe-based techniques—contact resonance, force volume, and scanning spreading resistance microscopy—along with cryo-scanning transmission electron microscopy, electron energy loss spectroscopy, and energy dispersive X-ray spectroscopy.more » We show that lithium becomes trapped in the binder during cycling and results in large initial capacity losses, the formation of dendrite-like features, column-like domains of significantly increased mechanical modulus, and a slight increase in electronic resistivity.« less
  9. Generalized rate theory for void and bubble swelling and its application to δ-plutonium

    A rate theory for void and bubble swelling is derived that allows both vacancies and self-interstitial atoms to be generated by thermal activation at all sinks. In addition, they can also be produced by displacement damage from external and internal radiation. This generalized rate theory (GRT) is applied to swelling of gallium-stabilized δ-plutonium in which α-decay causes the displacement damage. Since the helium atoms produced also become trapped in vacancies, a distinction is made between empty and occupied vacancies. The growth of helium bubbles observed by transmission electron microscopy in weapons-grade and in material enriched with Pu238 is analyzed, usingmore » different values for the formation energy of self-interstitial atoms (SIA) and two different sets of relaxation volumes for the vacancy and for the SIA. One set allows preferential capture of SIA at dislocations, while the other set gives equal preference to both vacancy and SIA. It is found that the helium bubble diameters observed are in better agreement with GRT predictions if no preferential capture occurs at dislocations. Therefore, helium bubbles in δ-plutonium will not evolve into voids. Furthermore, the helium density within the bubbles remains sufficiently high to cause thermal emission of SIA. Based on a helium density between two to three helium atoms per vacant site, the sum of formation and migration energies must be around 2.0 eV for SIA in δ-plutonium.« less
  10. Magnetic metamaterials by ion-implantation

    We present a method for the additive fabrication of planar magnetic nanoarrays with minimal surface roughness. Synthesis is accomplished by combining electron-beam lithography, used to generate nanometric patterned masks, with ion implantation in thin films. By implanting 56Fe+ ions, we are able to introduce magnetic functionality in a controlled manner into continuous Pd thin films, achieving 3D spatial resolution down to a few tens of nanometers. Our results demonstrate the application of this technique in fabricating square artificial spin ice lattices, which exhibit well-defined magnetization textures and interactions among the patterned magnetic elements.
...

Search for:
All Records
Subject
Electron microscopy

Refine by:
Article Type
Availability
Journal
Creator / Author
Publication Date
Research Organization