Area-based composition predictions of materials fabricated using simultaneous wire-powder-directed energy deposition

Journal Article · 04 November 2024 · Additive Manufacturing Letters

DOI: https://doi.org/10.1016/j.addlet.2024.100254 · OSTI ID:2476862

Bozeman, Scott C.  ^[1]; Isgor, O. Burkan ^[1]; Tucker, Julie D. ^[1]

---

1. Oregon State University, Corvallis, OR (United States)

Functionally graded materials are an emergent method for designing components with programmable site-specific material properties. These materials are typically fabricated using metal additive manufacturing tools by simultaneously feeding multiple wire and/or powder feedstocks at various rates to achieve spatial composition change. The wire-powder-directed energy deposition (WP-DED) technique is of particular interest for many functionally graded material applications by balancing the low raw materials cost of wire with the high resolution of powder. However, feeding wire and powder are inherently different processes since all extruded wire enters the melt pool, while much of the blown powder is scattered, which makes determining the composition of the build challenging. In this study, we devise a simple area-based measurement method for estimating the composition of WP-DED structures. WP-DED single beads are printed using 309L stainless steel wire and commercially pure Fe powder at five wire feed rates (0.5, 0.75, 1.00, 1.25, 1.50 mm/mm) and five powder feed rates (2, 4, 6, 8, 10 rpm). Characteristic defects including interface gaps and macrosegregation (lack of mixing) tendencies are examined. High powder feed rates (8, 10 rpm) result in interface gaps at all wire feed rates, but smooth deposition and complete mixing is achieved at low powder feed rates, particularly with lower wire feed rates as well. The area-based composition measurement method is within ±20% of energy dispersive x-ray spectroscopy measurements for all samples, showing its effectiveness as a rapid composition estimate for WP-DED materials development.

• Research Organization: Oregon State University, Corvallis, OR (United States)
• Sponsoring Organization: National Science Foundation (NSF); USDOE Office of Energy Efficiency and Renewable Energy (EERE), Renewable Power Office. Water Power Technologies Office
• Grant/Contract Number: EE0009969
• OSTI ID: 2476862
• Journal Information: Additive Manufacturing Letters, Journal Name: Additive Manufacturing Letters Vol. 11; ISSN 2772-3690
• Publisher: ElsevierCopyright Statement
• Country of Publication: United States
• Language: English