Title: Investigating the minimum post-burst energy required to function an exploding bridgewire detonator

Journal Article · · Journal of Applied Physics
DOI: https://doi.org/10.1063/5.0006804 · OSTI ID:1830578

The minimum energy required after bridge-burst to function a commercially available RP-1 exploding bridgewire detonator with a gold bridgewire was investigated using two capacitor discharge units (CDUs) making use of state-of-the-art on/off high-voltage high-current switches. Both switches are capable of shutting off the current flow in ≈100ns and the conduction time was varied systematically to limit the duration of electrical energy delivered from the CDU until a detonation go/no-go threshold was reached. It was found that the minimal extra electrical energy required for a soft-fire (a statistically marginal go) was approximately half that required for a hard-fire (a definite go). Furthermore, the measured energy required to function the RP-1 detonator from the 11.5 kV CDU was approximately 20 mJ greater than for the 600 V CDU, and it is postulated that this was due to arcing across the detonator terminals and an associated current shunt that was not efficient at depositing energy conducive to detonator functioning. Measurements of the bridgewire temperatures bursting in air showed that the maximum temperature reached was consistent (≈18kK) when sufficient energy was delivered that the detonator functioned (either soft- or hard-fire), but that the temperature for a sub-threshold bridgewire burst was significantly cooler at approximately 8 kK. Furthermore, it was demonstrated that the intensity of the light emitted at burst scaled with deposited energy. A related finding is that the light emission from the bridgewire peaks some tens of nanoseconds after both peak voltage and peak electrical power.

Research Organization:
Los Alamos National Laboratory (LANL), Los Alamos, NM (United States)
Sponsoring Organization:
USDOE National Nuclear Security Administration (NNSA)
Grant/Contract Number:
89233218CNA000001
OSTI ID:
1830578
Report Number(s):
LA-UR-20-22169; LA-UR-20-23057
Journal Information:
Journal of Applied Physics, Journal Name: Journal of Applied Physics Journal Issue: 3 Vol. 128; ISSN 0021-8979
Publisher:
American Institute of Physics (AIP)Copyright Statement
Country of Publication:
United States
Language:
English

References (12)

Electric Detonators: EBW and EFI journal June 1996
Thermodynamic Properties of Gold journal January 2016
Melting and Volume Vaporization Kinetics Effects in Tungsten Wires at the Heating Rates of 10 12 to 10 13 K/s journal July 2004
Factors affecting energy deposition and expansion in single wire low current experiments journal August 2004
Effect of current rate on energy deposition into exploding metal wires in vacuum journal October 2004
Thermodynamical calculation of metal heating in nanosecond exploding wire and foil experiments journal January 2007
Experimental investigations on energy deposition and morphology of exploding aluminum wires in argon gas journal March 2019
Finding the “lost-time” in detonator function journal March 2019
Electrical resistivity of copper, gold, palladium, and silver journal October 1979
A review of the mechanism by which exploding bridge-wire detonators function journal July 2019
Nanosecond electrical explosion of thin aluminum wires in a vacuum: Experimental and computational investigations journal April 2005
Experimental Investigations on Specific Energy Deposition and Burst Characteristics in Electrically Exploded Single Copper Wires journal January 2019