DOE PAGES title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Propane liquefaction with an active magnetic regenerative liquefier

Abstract

Magnetic refrigeration is a well-known cooling technique based on the magnetocaloric effect (MCE) of certain solids as they enter or leave a high magnetic field. An active magnetic regenerator (AMR) uses certain ferromagnetic materials simultaneously as MCE refrigerants and as a regenerator. An effective active magnetic regenerative refrigeration cycle consists of four steps: adiabatic magnetization with no heat transfer gas flow; heat transfer gas flow at constant high field; demagnetization with no heat transfer gas flow; and heat transfer gas flow at constant low field. The first heat transfer gas flow step from a cold-to-hot temperature in this cycle rejects heat from the magnetized regenerator to a hot sink and the second reverse heat transfer gas flow step from a hot-to-cold temperature absorbs heat from a cold source. Our primary objectives of the present work were to demonstrate an AMR-cycle liquefier, determine the cooling power of a magnetic refrigerant executing an AMR cycle, and understand the impact of intermittent cooling of the AMR cycle of a reciprocating, dual regenerator design with continuous liquefaction and parasitic heat leaks. This article describes how an AMR-cycle refrigerator using Gd regenerators moving through ~2.7 T changes at 0.25 Hz was used to liquefy puremore » propane at two different supply pressures. The measured rates of liquefaction and elapsed times were measured and used to determine the volume collected and derive cooling power at liquefaction conditions for both runs. These results were compared to those obtained from cool-down temperature vs. time data during the same run. Furthermore, the agreement between the two, independent cooling-power results was excellent after the duty cycle of the AMR cycle cooling was properly treated. No direct measurements of the efficiency were made.« less

Authors:
ORCiD logo [1];  [2];  [3];  [2];  [2];  [2];  [2]
  1. Emerald Energy NW, LLC. (EENW), Bothell, WA (United States)
  2. Pacific Northwest National Lab. (PNNL), Richland, WA (United States)
  3. Pacific Northwest National Lab. (PNNL), Richland, WA (United States); Ames Lab. and Iowa State Univ., Ames, IA (United States)
Publication Date:
Research Org.:
Ames Lab., Ames, IA (United States)
Sponsoring Org.:
USDOE
OSTI Identifier:
1542933
Alternate Identifier(s):
OSTI ID: 1775715
Report Number(s):
IS-J-9965
Journal ID: ISSN 0011-2275
Grant/Contract Number:  
AC02-07CH11358
Resource Type:
Accepted Manuscript
Journal Name:
Cryogenics
Additional Journal Information:
Journal Volume: 100; Journal Issue: C; Journal ID: ISSN 0011-2275
Publisher:
Elsevier
Country of Publication:
United States
Language:
English
Subject:
75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND SUPERFLUIDITY; Propane; Liquefaction; Active-magnetic-regenerator; Load-curve; Coil-fin-tube-heat-exchanger; Gd

Citation Formats

Barclay, John, Brooks, Kriston, Cui, Jun, Holladay, Jamelyn, Meinhardt, Kerry, Polikarpov, Evgueni, and Thomsen, Edwin. Propane liquefaction with an active magnetic regenerative liquefier. United States: N. p., 2019. Web. doi:10.1016/j.cryogenics.2019.01.009.
Barclay, John, Brooks, Kriston, Cui, Jun, Holladay, Jamelyn, Meinhardt, Kerry, Polikarpov, Evgueni, & Thomsen, Edwin. Propane liquefaction with an active magnetic regenerative liquefier. United States. https://doi.org/10.1016/j.cryogenics.2019.01.009
Barclay, John, Brooks, Kriston, Cui, Jun, Holladay, Jamelyn, Meinhardt, Kerry, Polikarpov, Evgueni, and Thomsen, Edwin. Wed . "Propane liquefaction with an active magnetic regenerative liquefier". United States. https://doi.org/10.1016/j.cryogenics.2019.01.009. https://www.osti.gov/servlets/purl/1542933.
@article{osti_1542933,
title = {Propane liquefaction with an active magnetic regenerative liquefier},
author = {Barclay, John and Brooks, Kriston and Cui, Jun and Holladay, Jamelyn and Meinhardt, Kerry and Polikarpov, Evgueni and Thomsen, Edwin},
abstractNote = {Magnetic refrigeration is a well-known cooling technique based on the magnetocaloric effect (MCE) of certain solids as they enter or leave a high magnetic field. An active magnetic regenerator (AMR) uses certain ferromagnetic materials simultaneously as MCE refrigerants and as a regenerator. An effective active magnetic regenerative refrigeration cycle consists of four steps: adiabatic magnetization with no heat transfer gas flow; heat transfer gas flow at constant high field; demagnetization with no heat transfer gas flow; and heat transfer gas flow at constant low field. The first heat transfer gas flow step from a cold-to-hot temperature in this cycle rejects heat from the magnetized regenerator to a hot sink and the second reverse heat transfer gas flow step from a hot-to-cold temperature absorbs heat from a cold source. Our primary objectives of the present work were to demonstrate an AMR-cycle liquefier, determine the cooling power of a magnetic refrigerant executing an AMR cycle, and understand the impact of intermittent cooling of the AMR cycle of a reciprocating, dual regenerator design with continuous liquefaction and parasitic heat leaks. This article describes how an AMR-cycle refrigerator using Gd regenerators moving through ~2.7 T changes at 0.25 Hz was used to liquefy pure propane at two different supply pressures. The measured rates of liquefaction and elapsed times were measured and used to determine the volume collected and derive cooling power at liquefaction conditions for both runs. These results were compared to those obtained from cool-down temperature vs. time data during the same run. Furthermore, the agreement between the two, independent cooling-power results was excellent after the duty cycle of the AMR cycle cooling was properly treated. No direct measurements of the efficiency were made.},
doi = {10.1016/j.cryogenics.2019.01.009},
journal = {Cryogenics},
number = C,
volume = 100,
place = {United States},
year = {Wed Apr 24 00:00:00 EDT 2019},
month = {Wed Apr 24 00:00:00 EDT 2019}
}

Journal Article:

Citation Metrics:
Cited by: 10 works
Citation information provided by
Web of Science

Save / Share:

Works referenced in this record:

A rotary magnetic refrigerator for superfluid helium production
journal, November 1986

  • Hakuraku, Y.; Ogata, H.
  • Journal of Applied Physics, Vol. 60, Issue 9
  • DOI: 10.1063/1.337716

Magnetic heat pumping near room temperature
journal, August 1976

  • Brown, G. V.
  • Journal of Applied Physics, Vol. 47, Issue 8
  • DOI: 10.1063/1.323176

Stirling‐cycle rotating magnetic refrigerators and heat engines for use near room temperature
journal, March 1978

  • Steyert, W. A.
  • Journal of Applied Physics, Vol. 49, Issue 3
  • DOI: 10.1063/1.325009

Investigation of bypass fluid flow in an active magnetic regenerative liquefier
journal, July 2018


Experimental investigation of a three-material layered active magnetic regenerator
journal, December 2006


Thermodynamics of active magnetic regenerators: Part I
journal, February 2012


Thermodynamics of active magnetic regenerators: Part II
journal, February 2012


Thermodynamic investigations of optimum active magnetic regenerators
journal, February 1998


Numerical analysis of active magnetic regenerators for hydrogen magnetic refrigeration between 20 and 77K
journal, June 2011


Magnetic refrigerator for hydrogen liquefaction
journal, July 2014


Experimental investigation of two-stage active magnetic regenerative refrigerator operating between 77K and 20K
journal, October 2013


A review of magnetic refrigerator and heat pump prototypes built before the year 2010
journal, September 2010


Magnetocaloric effect and heat capacity in the phase-transition region
journal, January 1999

  • Tishin, A. M.; Gschneidner, K. A.; Pecharsky, V. K.
  • Physical Review B, Vol. 59, Issue 1
  • DOI: 10.1103/PhysRevB.59.503

Magnetic phase transitions and the magnetothermal properties of gadolinium
journal, February 1998


Works referencing / citing this record:

Energy Applications of Magnetocaloric Materials
journal, March 2020