skip to main content


This content will become publicly available on September 23, 2018

Title: Application of the backward extrapolation method to pulsed neutron sources

We report particle detectors operated in pulse mode are subjected to the dead-time effect. When the average of the detector counts is constant over time, correcting for the dead-time effect is simple and can be accomplished by analytical formulas. However, when the average of the detector counts changes over time it is more difficult to take into account the dead-time effect. When a subcritical nuclear assembly is driven by a pulsed neutron source, simple analytical formulas cannot be applied to the measured detector counts to correct for the dead-time effect because of the sharp change of the detector counts over time. This work addresses this issue by using the backward extrapolation method. The latter can be applied not only to a continuous (e.g. californium) external neutron source but also to a pulsed external neutron source (e.g. by a particle accelerator) driving a subcritical nuclear assembly. Finally, the backward extrapolation method allows to obtain from the measured detector counts both the dead-time value and the real detector counts.
 [1] ;  [1]
  1. Argonne National Lab. (ANL), Argonne, IL (United States). Nuclear Engineering Division
Publication Date:
Grant/Contract Number:
Accepted Manuscript
Journal Name:
Nuclear Instruments and Methods in Physics Research. Section A, Accelerators, Spectrometers, Detectors and Associated Equipment
Additional Journal Information:
Journal Volume: 877; Journal ID: ISSN 0168-9002
Research Org:
Argonne National Lab. (ANL), Argonne, IL (United States)
Sponsoring Org:
USDOE Office of Nuclear Energy (NE), International Nuclear Energy Policy and Cooperation (NE-6); USDOE National Nuclear Security Administration (NNSA)
Country of Publication:
United States
43 PARTICLE ACCELERATORS; Dead time; Paralyzable; Backward extrapolation; YALINA; Pulsed neutron source
OSTI Identifier: