skip to main content
DOE Data Explorer title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence F - Raw Data

Abstract

Sequence F: Downwind High Cone (F) This test sequence used a downwind, rigid turbine with an 18° cone angle. The wind speed ranged from 10 m/s to 20 m/s. Excessive inertial loading due to the high cone angle prevented operation at lower wind speeds. Yaw angles of ±20° were achieved. The blade tip pitch was 3°. The rotor rotated at 72 RPM. Blade and probe pressure measurements were collected. The teeter dampers were replaced with rigid links, and these two channels were flagged as not applicable by setting the measured values in the data file to –99999.99 Nm. The teeter link was replaced with a shorter bar so the load cell was not installed during this test. However, the teeter link load cell channel was flagged as not applicable by setting the measured values in the data file to -99999.99 N.

Creator(s)/Author(s):
Publication Date:
DOE Contract Number:  
67025F
Product Type:
Dataset
Research Org.:
Atmosphere to Electrons (A2e) Data Archive and Portal, Pacific Northwest National Laboratory; PNNL
Sponsoring Org.:
USDOE Office of Energy Efficiency and Renewable Energy (EERE), Wind and Water Technologies Office (EE-4W)
Subject:
17 Wind Energy
OSTI Identifier:
1483641
DOI:
10.21947/1483641

Citation Formats

Fingersh, Lee. UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence F - Raw Data. United States: N. p., 2019. Web. doi:10.21947/1483641.
Fingersh, Lee. UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence F - Raw Data. United States. doi:10.21947/1483641.
Fingersh, Lee. 2019. "UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence F - Raw Data". United States. doi:10.21947/1483641. https://www.osti.gov/servlets/purl/1483641. Pub date:Wed Dec 11 00:00:00 EST 2019
@article{osti_1483641,
title = {UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence F - Raw Data},
author = {Fingersh, Lee},
abstractNote = {Sequence F: Downwind High Cone (F) This test sequence used a downwind, rigid turbine with an 18° cone angle. The wind speed ranged from 10 m/s to 20 m/s. Excessive inertial loading due to the high cone angle prevented operation at lower wind speeds. Yaw angles of ±20° were achieved. The blade tip pitch was 3°. The rotor rotated at 72 RPM. Blade and probe pressure measurements were collected. The teeter dampers were replaced with rigid links, and these two channels were flagged as not applicable by setting the measured values in the data file to –99999.99 Nm. The teeter link was replaced with a shorter bar so the load cell was not installed during this test. However, the teeter link load cell channel was flagged as not applicable by setting the measured values in the data file to -99999.99 N.},
doi = {10.21947/1483641},
journal = {},
number = ,
volume = ,
place = {United States},
year = {2019},
month = {12}
}

Dataset:

Save / Share: