skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Multifilament Fibers Based on Dissolution of Cellulose in NaOH/Urea Aqueous Solution: Structure and Properties

Abstract

High-quality cellulose multifilaments are spun using a preliminary pilot apparatus, from the cellulose dope in an NaOH and urea aqueous solution precooled to -12 {sup o}C, by using a low-cost, simple, and environmentally friendly process. Small-angle X-ray scattering patterns indicate that the orientation of the multifilaments increase with a drawing process, leading to the improvement of their tensile strength.

Authors:
; ; ; ; ; ; ;
Publication Date:
Research Org.:
Brookhaven National Laboratory (BNL) National Synchrotron Light Source
Sponsoring Org.:
Doe - Office Of Science
OSTI Identifier:
930410
Report Number(s):
BNL-81140-2008-JA
Journal ID: ISSN 0935-9648; ADVMEW; TRN: US200904%%536
DOE Contract Number:
DE-AC02-98CH10886
Resource Type:
Journal Article
Resource Relation:
Journal Name: Advanced Materials; Journal Volume: 19; Journal Issue: 6
Country of Publication:
United States
Language:
English
Subject:
37 INORGANIC, ORGANIC, PHYSICAL AND ANALYTICAL CHEMISTRY; AQUEOUS SOLUTIONS; CELLULOSE; DISSOLUTION; FIBERS; ORIENTATION; SODIUM HYDROXIDES; TENSILE PROPERTIES; UREA; national synchrotron light source

Citation Formats

Cai,J., Zhang, L., Zhou, J., Qi, H., Chen, H., Kondo, T., Chen, X., and Chu, B. Multifilament Fibers Based on Dissolution of Cellulose in NaOH/Urea Aqueous Solution: Structure and Properties. United States: N. p., 2007. Web. doi:10.1002/adma.200601521.
Cai,J., Zhang, L., Zhou, J., Qi, H., Chen, H., Kondo, T., Chen, X., & Chu, B. Multifilament Fibers Based on Dissolution of Cellulose in NaOH/Urea Aqueous Solution: Structure and Properties. United States. doi:10.1002/adma.200601521.
Cai,J., Zhang, L., Zhou, J., Qi, H., Chen, H., Kondo, T., Chen, X., and Chu, B. Mon . "Multifilament Fibers Based on Dissolution of Cellulose in NaOH/Urea Aqueous Solution: Structure and Properties". United States. doi:10.1002/adma.200601521.
@article{osti_930410,
title = {Multifilament Fibers Based on Dissolution of Cellulose in NaOH/Urea Aqueous Solution: Structure and Properties},
author = {Cai,J. and Zhang, L. and Zhou, J. and Qi, H. and Chen, H. and Kondo, T. and Chen, X. and Chu, B.},
abstractNote = {High-quality cellulose multifilaments are spun using a preliminary pilot apparatus, from the cellulose dope in an NaOH and urea aqueous solution precooled to -12 {sup o}C, by using a low-cost, simple, and environmentally friendly process. Small-angle X-ray scattering patterns indicate that the orientation of the multifilaments increase with a drawing process, leading to the improvement of their tensile strength.},
doi = {10.1002/adma.200601521},
journal = {Advanced Materials},
number = 6,
volume = 19,
place = {United States},
year = {Mon Jan 01 00:00:00 EST 2007},
month = {Mon Jan 01 00:00:00 EST 2007}
}
  • In this study, structure changes of regenerated cellulose fibers wet-spun from a cotton linter pulp (degree of polymerization {approx}620) solution in an NaOH/urea solvent under different conditions were investigated by simultaneous synchrotron wide-angle X-ray diffraction (WAXD) and small-angle X-ray scattering (SAXS). WAXD results indicated that the increase in flow rate during spinning produced a better crystal orientation and a higher degree of crystallinity, whereas a 2-fold increase in draw ratio only affected the crystal orientation. When coagulated in a H{sub 2}SO{sub 4}/Na{sub 2}SO{sub 4} aqueous solution at 15 {sup o}C, the regenerated fibers exhibited the highest crystallinity and a crystalmore » orientation comparable to that of commercial rayon fibers by the viscose method. SAXS patterns exhibited a pair of meridional maxima in all regenerated cellulose fibers, indicating the existence of a lamellar structure. A fibrillar superstructure was observed only at higher flow rates (>20 m/min). The conformation of cellulose molecules in NaOH/urea aqueous solution was also investigated by static and dynamic light scattering. It was found that cellulose chains formed aggregates with a radius of gyration, R{sub g}, of about 232 nm and an apparent hydrodynamic radius, R{sub h}, of about 172 nm. The NaOH/urea solvent system is low-cost and environmentally friendly, which may offer an alternative route to replace more hazardous existing methods for the production of regenerated cellulose fibers.« less
  • Regenerated cellulose fibers were fabricated by dissolution of cotton linter pulp in NaOH (9.5 wt%) and thiourea (4.5 wt%) aqueous solution followed by wet-spinning and multi-roller drawing. The multi-roller drawing process involved three stages: coagulation (I), coagulation (II) and post-treatment (III). The crystalline structure and morphology of regenerated cellulose fiber was investigated by synchrotron wide-angle X-ray diffraction (WAXD) and small-angle X-ray scattering (SAXS) techniques. Results indicated that only the cellulose II crystal structure was found in regenerated cellulose fibers, proving that the cellulose crystals were completely transformed from cellulose I to II structure during spinning from NaOH/thiourea aqueous solution. Themore » crystallinity, orientation and crystal size at each stage were determined from the WAXD analysis. Drawing of cellulose fibers in the coagulation (II) bath (H{sub 2}SO{sub 4}/H{sub 2}O) was found to generate higher orientation and crystallinity than drawing in the post-treatment (III). Although the post-treatment process also increased crystal orientation, it led to a decrease in crystallinity with notable reduction in the anisotropic fraction. Compared with commercial rayon fibers fabricated by the viscose process, the regenerated cellulose fibers exhibited higher crystallinity but lower crystal orientation. SAXS results revealed a clear scattering maximum along the meridian direction in all regenerated cellulose fibers, indicating the formation of lamellar structure during spinning.« less
  • Neutron diffraction with isotopic substitution has been used to investigate aqueous solutions of 2M NaOH in the liquid state. The data were modeled using empirical potential structure refinement which allows for the extraction of the ion-water and water-water correlations. The data show that the ion-water radial distribution functions are in accordance with those found by previous studies on NaOH solutions and follow a trend which is dependent on the concentration of the solute. In particular, the shape of the hydroxide hydration shell is found to be concentration independent, but the number of water molecules occupying this shell increases with dilution.more » Additionally, the water-water correlations show that there is still a measurable effect on water structure with the addition of ions at this concentration, as the second shell in the water oxygen radial distribution function is compressed relative to the first shell. The data are also used to discuss the recent claims that the published radial distribution functions of water are unreliable, showing that data taken at different neutron sources, with different diffraction geometry and systematic errors lead to the same structural information when analyzed via a realistic modeling regime.« less
  • Europium-doped yttrium oxide phosphors were prepared by firing precursors obtained by urea solvothermal method. The nature of solvents plays an important role in determining the structure and chemical composition of the precursor compounds. Amorphous hydroxides/carbonates mixture, amorphous carbonates and crystalline carbonates were obtained by urea solvothermal reactions from ethylenediamine, ethanol and aqueous media, respectively. The morphology and particle size distribution of the phosphor particles were studied by SEM and dynamic laser scattering method. The photoluminescence of the phosphor prepared by urea solvothermal method is improved as compared with that of the phosphor obtained by conventional urea homogeneous precipitation method. Ureamore » solvothermal method provides a possible way to tailor the properties of a variety of carbonates and oxides by exploiting the nature of different solvents.« less
  • Europium-doped yttrium oxide phosphors were obtained by firing precursors prepared by urea precipitation in ethanol and ethylenediamine. The precipitation in non-aqueous solution was carried out in an autoclave at 150 C to allow the decomposition of urea. The photoluminescent intensities of the phosphors prepared in ethanol and ethylenediamine increased by about 30% compared to that of the phosphor prepared by the conventional urea homogeneous precipitation in aqueous solution. Amorphous carbonates and amorphous hydroxides/carbonates mixtures were identified as precursors from ethanol and ethylenediamine, respectively. The morphology and particle size were studied by SEM and dynamic laser scattering method.