Performance of a Drum Type Packaging with Urethane Foam Overpack Subjected to Crush and Other Regulatory Tests
In order to improve the melt rate of high level waste slurry feed being vitrified in the Savannah River Site's (SRS) Defense Waste Processing Facility (DWPF) Melter, a melter glass pump (pump 1) was installed in the DWPF Melter on February 10, 2004. The glass pump increased melt rate by generating a forced convection within the molten glass pool, thereby increasing the heat transfer from the molten glass to the unmolten feed cold cap that is on top of the glass pool. After operating for over four months, the pump was removed on June 22, 2004 due to indications that it had failed. The removed pump exhibited obvious signs of corrosion, had collapsed inward at the glass exit slots at the melt line, and was dog-legged in the same area. This lead to the pump being redesigned to improve its mechanical integrity (increased wall thickness and strength) while maintaining its hydraulic diameter as large as possible. The improved DWPF glass pump (pump 2) was installed on September 15, 2004. The impact of the new design on pump life, along with analysis of the glass pump's impact on melt rate in the DWPF Melter is discussed in this paper.
- Research Organization:
- Savannah River Site (SRS), Aiken, SC (United States)
- Sponsoring Organization:
- US Department of Energy (US)
- DOE Contract Number:
- AC09-96SR18500
- OSTI ID:
- 839354
- Report Number(s):
- WSRC-TR-2004-00601; TRN: US0502484
- Resource Relation:
- Conference: 2005 ASME Pressure Vessels and Piping Conference, Denver, CO (US), 07/17/2005--07/21/2005; Other Information: PBD: 17 Jul 2005
- Country of Publication:
- United States
- Language:
- English
Similar Records
The Impact of the Source of Alkali on Sludge Batch 3 Melt Rate (U)
Yield Stress Reduction of DWPF Melter Feed Slurries