Abort kicker power supply systems at Fermilab
Over the past several years, Fermilab has been operating with a single turn proton abort system in both the superconducting Tevatron and the conventional Main Ring. The abort kicker power supply for this system discharges a lumped capacitance into the inductive magnet load, causing the beam to enter the abort channel. The characteristics of this current waveform are defined by the requirements of the machine operation. The standard fixed target running mode calls for 12 booster batches of beam which leaves a rotating gap in the beam of about1.8 ..mu..s. The current waveform is required to rise to 90% of I /SUB max/ in this time to avoid beam loss from partially deflected beam. Aperture limitations in both the accelerator and the abort channel demand that the current in the magnets stays above this 90% I for the 21 ..mu..s needed to ensure all the beam has /SUP max/ left the machine. The 25 mm displacement needed to cleanly enter the abort channel at 1 TeV corresponds to a maximum current in each of the 4 modules of about20 kA. Similar constraints are needed for the Main Ring and Tevatron antiproton abort systems. A unique feature of this design is the high voltage, high current diode assembly used to clip the recharge of the capacitor bank. This allows the current to decay slowly with the L/R time constant of the magnet and diode series combination. Special attention will be given to the diode characteristics needed for this passive switching element. Operational experience and proposed upgrades will be given for the two operational systems.
- Research Organization:
- Fermi National Accelerator Laboratory, Batavia, IL
- OSTI ID:
- 5948436
- Report Number(s):
- CONF-850504-
- Journal Information:
- IEEE Trans. Nucl. Sci.; (United States), Vol. NS-32:5; Conference: Particle accelerator conference, Vancouver, Canada, 13 May 1985
- Country of Publication:
- United States
- Language:
- English
Similar Records
3kG kicker magnet system for the tevatron beam abort system
Kicker and Pulser Systems-Required for Pbar Manipulations in the Main Ring and Tevatron
Related Subjects
KICKER MAGNETS
POWER SUPPLIES
PERFORMANCE
DESIGN
FERMILAB ACCELERATOR
FERMILAB TEVATRON
ACCELERATORS
CYCLIC ACCELERATORS
ELECTRICAL EQUIPMENT
ELECTROMAGNETS
ELECTRONIC EQUIPMENT
EQUIPMENT
MAGNETS
SYNCHROTRONS
430303* - Particle Accelerators- Experimental Facilities & Equipment