An experimental study of turbine vane heat transfer with water-air cooling
- Allison Engine Co., Indianapolis, IN (United States)
This paper presents data showing the improvement in cooling effectiveness of turbine vanes through the application of water-air cooling technology in an industrial/utility engine application. The technique utilizes a finely dispersed water-in-air mixture that impinges on the internal surfaces of turbine airfoils to produce very high cooling rates. An airfoil was designed to contain a standard impingement tube, which distributes the water-air mixture over the inner surface of the airfoil. The water flash vaporizes off the airfoil inner wall. The resulting mixture of air-steam-water droplets is then routed through a pin fin array in the trailing edge region of the airfoil where additional water is vaporized. The mixture then exits the airfoil into the gas path through trailing edge slots. Experimental measurements were made in a three-vane, linear, two-dimensional cascade. The principal independent parameters--Mach number, Reynolds number, wall-to-gas temperature ratio, and coolant-to-gas mass flow ratio--were maintained over ranges consistent with typical engine conditions. Five impingement tubes were utilized to study geometry scaling, impingement tube-to-airfoil wall gap spacing, impingement tube hole diameter, and impingement tube hole patterns. The test matrix was structured to provide an assessment of the independent influence of parameters of interest, namely, exit Mach number, exit Reynolds number, gas-to-coolant temperature ratio, water- and air-coolant-to-gas mass flow ratios, and impingement tube geometry. Heat transfer effectiveness data obtained in this program demonstrated that overall cooling levels typical for air-cooled vanes could be achieved with the water-air cooling technique with reductions of cooling air flow of significantly more than 50%.
- Sponsoring Organization:
- USDOE
- OSTI ID:
- 290074
- Report Number(s):
- CONF-960608-; ISSN 0889-504X; TRN: IM9834%%203
- Journal Information:
- Journal of Turbomachinery, Vol. 120, Issue 1; Conference: 41. American Society of Mechanical Engineers (ASME) international gas turbine and aeroengine congress and exposition, Birmingham (United Kingdom), 10-13 Jun 1996; Other Information: PBD: Jan 1998
- Country of Publication:
- United States
- Language:
- English
Similar Records
Predictions of flow and heat transfer in sharp 180-deg turns of gas turbine coolant channels with and without turning vanes
Revolutionizing Turbine Cooling with Micro-Architectures Enabled by Direct Metal Laser Sintering