Effects of gas to melt ratio on the microstructure of an Al–10.83Zn–3.39Mg–1.22Cu alloy produced by spray atomization and deposition
- School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001 (China)
- School of Mechanical and Mining Engineering, The University of Queensland, St Lucia, QLD 4072 (Australia)
Various gas to melt ratios (GMR) that govern the cooling rate of spray forming can be achieved through controlling the atomizer form and the atomization pressure. The effect of the GMR on microstructures of an Al–10.83Zn–3.39Mg–1.22Cu alloy produced through spray forming has been studied using electron microscopy. When the GMR is high at 3.5, dendritic structure and quasi-crystalline i-Mg{sub 32}(AlZn){sub 49} particles inherited from the original powders can be observed. Spray forming at medium GMR of 2.3 produces equiaxed α-Al grains and MgZn{sub 2} phase that discontinuously distributes along the grain boundaries and within the grains as small particles. The low GMR of 1.4 corresponds to low cooling rate. Coarse and equiaxed α-Al grains together with eutectic structure consisting of b.c.c.-Mg{sub 32}(AlZn){sub 49} and α-Al phases along the grain boundaries are obtained. - Highlights: • At high GMR, the broken fragments and i-Mg{sub 32}(AlZn){sub 49} quasicrystal are observed. • At medium GMR, microstructure consists of α-Al equiaxed grains and MgZn{sub 2} phase. • At low GMR, the coarsened α-Al grains and bcc-Mg{sub 32}(AlZn){sub 49} eutectic appear.
- OSTI ID:
- 22288721
- Journal Information:
- Materials Characterization, Vol. 87; Other Information: Copyright (c) 2013 Elsevier Science B.V., Amsterdam, The Netherlands, All rights reserved.; Country of input: International Atomic Energy Agency (IAEA); ISSN 1044-5803
- Country of Publication:
- United States
- Language:
- English
Similar Records
Influence of severe plastic deformation on intermetallic particles in Mg-12 wt.%Zn alloy investigated using transmission electron microscopy
Microstructural characteristics of 5083 Al alloys processed by reactive spray deposition for net-shape manufacturing