skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: The interaction of high-speed turbulence with flames: Turbulent flame speed

Abstract

Direct numerical simulations of the interaction of a premixed flame with driven, subsonic, homogeneous, isotropic, Kolmogorov-type turbulence in an unconfined system are used to study the mechanisms determining the turbulent flame speed, S{sub T}, in the thin reaction zone regime. High intensity turbulence is considered with the r.m.s. velocity 35 times the laminar flame speed, S{sub L}, resulting in the Damkoehler number Da=0.05. The simulations were performed with Athena-RFX, a massively parallel, fully compressible, high-order, dimensionally unsplit, reactive-flow code. A simplified reaction-diffusion model, based on the one-step Arrhenius kinetics, represents a stoichiometric H{sub 2}-air mixture under the assumption of the Lewis number Le=1. Global properties and the internal structure of the flame were analyzed in an earlier paper, which showed that this system represents turbulent combustion in the thin reaction zone regime. This paper demonstrates that: (1) The flame brush has a complex internal structure, in which the isosurfaces of higher fuel mass fractions are folded on progressively smaller scales. (2) Global properties of the turbulent flame are best represented by the structure of the region of peak reaction rate, which defines the flame surface. (3) In the thin reaction zone regime, S{sub T} is predominantly determined by the increasemore » of the flame surface area, A{sub T}, caused by turbulence. (4) The observed increase of S{sub T} relative to S{sub L} exceeds the corresponding increase of A{sub T} relative to the surface area of the planar laminar flame, on average, by {approx}14%, varying from only a few percent to as high as {approx}30%. (5) This exaggerated response is the result of tight flame packing by turbulence, which causes frequent flame collisions and formation of regions of high flame curvature >or similar 1/{delta}{sub L}, or ''cusps,'' where {delta}{sub L} is the thermal width of the laminar flame. (6) The local flame speed in the cusps substantially exceeds its laminar value, which results in a disproportionately large contribution of cusps to S{sub T} compared with the flame surface area in them. (7) A criterion is established for transition to the regime significantly influenced by cusp formation. In particular, at Karlovitz numbers Ka >or similar 20, flame collisions provide an important mechanism controlling S{sub T}, in addition to the increase of A{sub T} by large-scale motions and the potential enhancement of diffusive transport by small-scale turbulence. (author)« less

Authors:
;  [1]
  1. Laboratory for Computational Physics and Fluid Dynamics, Naval Research Laboratory, Washington, DC 20375 (United States)
Publication Date:
OSTI Identifier:
21401359
Resource Type:
Journal Article
Journal Name:
Combustion and Flame
Additional Journal Information:
Journal Volume: 158; Journal Issue: 2; Other Information: Elsevier Ltd. All rights reserved; Journal ID: ISSN 0010-2180
Country of Publication:
United States
Language:
English
Subject:
37 INORGANIC, ORGANIC, PHYSICAL AND ANALYTICAL CHEMISTRY; LAMINAR FLAMES; CUSPED GEOMETRIES; COMBUSTION; SURFACE AREA; VELOCITY; TURBULENCE; AIR; HYDROGEN; COMPUTERIZED SIMULATION; COMBUSTION KINETICS; FLAME PROPAGATION; ZONES; LEWIS NUMBER; MIXTURES; DIFFUSION; STOICHIOMETRY; SURFACES; Premixed combustion; Flamelets

Citation Formats

Poludnenko, A Y, and Oran, E S. The interaction of high-speed turbulence with flames: Turbulent flame speed. United States: N. p., 2011. Web. doi:10.1016/J.COMBUSTFLAME.2010.09.002.
Poludnenko, A Y, & Oran, E S. The interaction of high-speed turbulence with flames: Turbulent flame speed. United States. https://doi.org/10.1016/J.COMBUSTFLAME.2010.09.002
Poludnenko, A Y, and Oran, E S. 2011. "The interaction of high-speed turbulence with flames: Turbulent flame speed". United States. https://doi.org/10.1016/J.COMBUSTFLAME.2010.09.002.
@article{osti_21401359,
title = {The interaction of high-speed turbulence with flames: Turbulent flame speed},
author = {Poludnenko, A Y and Oran, E S},
abstractNote = {Direct numerical simulations of the interaction of a premixed flame with driven, subsonic, homogeneous, isotropic, Kolmogorov-type turbulence in an unconfined system are used to study the mechanisms determining the turbulent flame speed, S{sub T}, in the thin reaction zone regime. High intensity turbulence is considered with the r.m.s. velocity 35 times the laminar flame speed, S{sub L}, resulting in the Damkoehler number Da=0.05. The simulations were performed with Athena-RFX, a massively parallel, fully compressible, high-order, dimensionally unsplit, reactive-flow code. A simplified reaction-diffusion model, based on the one-step Arrhenius kinetics, represents a stoichiometric H{sub 2}-air mixture under the assumption of the Lewis number Le=1. Global properties and the internal structure of the flame were analyzed in an earlier paper, which showed that this system represents turbulent combustion in the thin reaction zone regime. This paper demonstrates that: (1) The flame brush has a complex internal structure, in which the isosurfaces of higher fuel mass fractions are folded on progressively smaller scales. (2) Global properties of the turbulent flame are best represented by the structure of the region of peak reaction rate, which defines the flame surface. (3) In the thin reaction zone regime, S{sub T} is predominantly determined by the increase of the flame surface area, A{sub T}, caused by turbulence. (4) The observed increase of S{sub T} relative to S{sub L} exceeds the corresponding increase of A{sub T} relative to the surface area of the planar laminar flame, on average, by {approx}14%, varying from only a few percent to as high as {approx}30%. (5) This exaggerated response is the result of tight flame packing by turbulence, which causes frequent flame collisions and formation of regions of high flame curvature >or similar 1/{delta}{sub L}, or ''cusps,'' where {delta}{sub L} is the thermal width of the laminar flame. (6) The local flame speed in the cusps substantially exceeds its laminar value, which results in a disproportionately large contribution of cusps to S{sub T} compared with the flame surface area in them. (7) A criterion is established for transition to the regime significantly influenced by cusp formation. In particular, at Karlovitz numbers Ka >or similar 20, flame collisions provide an important mechanism controlling S{sub T}, in addition to the increase of A{sub T} by large-scale motions and the potential enhancement of diffusive transport by small-scale turbulence. (author)},
doi = {10.1016/J.COMBUSTFLAME.2010.09.002},
url = {https://www.osti.gov/biblio/21401359}, journal = {Combustion and Flame},
issn = {0010-2180},
number = 2,
volume = 158,
place = {United States},
year = {Tue Feb 15 00:00:00 EST 2011},
month = {Tue Feb 15 00:00:00 EST 2011}
}