Fast valve and nozzle for gas-puff operation of dense plasma focus
- Dense Plasma Group (GPDM), Instituto de Fisica Arroyo Seco, Universidad Nacional del Centro de la Provincia de Buenos Aires, Pinto 399, Tandil, Buenos Aires 7000 (Argentina) and CONICET, Avenida Rivadavia 1917, 1033 Buenos Aires (Argentina)
A simple and reliable valve and nozzle system for a very fast injection of gas has been designed and constructed for its use in gas-puff mode of dense plasma focus experiments. It delivers a very quick rise time: 55 {mu}s. The pressure measured in our setup at a distance of 15 mm from the nozzle output is about 0.285 mbar, with a plenum pressure of 3 bars (absolute). The time between the valve aperture and pressure front arrival is 360 {mu}s. This result comes up as an average of about a hundred measurements. The energy input is 95 J (270 V on a 3000 {mu}F capacitor bank). The typical dimensions of the valve are 52 mm in diameter and 80 mm in length. The entire volume of the valve is, then, very small. The relative low pressure and voltage operation are significant advantages of this development. The performance of the valve satisfactorily fulfills the objectives of gas-puff plasma focus operation.
- OSTI ID:
- 20778935
- Journal Information:
- Review of Scientific Instruments, Vol. 77, Issue 3; Other Information: DOI: 10.1063/1.2169535; (c) 2006 American Institute of Physics; Country of input: International Atomic Energy Agency (IAEA); ISSN 0034-6748
- Country of Publication:
- United States
- Language:
- English
Similar Records
A fast rise-rate, adjustable-mass-bit gas puff valve for energetic pulsed plasma experiments
Design and initial results from a kilojoule level dense plasma focus with hollow anode and cylindrically symmetric gas puff