Fabrication of large radii toroidal surfaces by single point diamond turning
- Oak Ridge National Lab., TN (United States)
- LEXMARK International, Inc., Lexington, KY (United States)
An unconventional machining technique has been developed for producing relatively large radii quasi-toroidal surfaces which could not normally be produced by conventional diamond turning technology. The maximum radial swing capacity of a diamond turning lathe is the limiting factor for the rotational radius of any toroid. A typical diamond turned toroidal surface is produced when a part is rotated about the spindle axis while the diamond tool contours the surface with any curved path. Toric surfaces sliced horizontally, have been used in laser resonator cavities. This paper will address the fabrication of a special case of toroids where a rotating tool path is a circle whose center is offset from the rotational axis of the toroid by a distance greater than the minor radius of the tool path. The quasi-toroidal surfaces produced by this technique approximate all asymmetrical combinations of concave/convex section of a torus. Other machine configurations have been reported which offer alternative approaches to the fabrication of concave asymmetric aspheric surfaces. Prototypes of unique lenses each having two quasi-toroidal surfaces were fabricated in the Ultraprecision Manufacturing Technology Center at form key components of a scanned laser focusing system. As an example of the problem faced, the specifications for one of the surfaces was equivalent to a section of a torus with a two meter diameter hole. The lenses were fabricated on a Nanoform 600 diamond turning lathe. This is a numerically controlled two axis T-base lathe with an air bearing spindle and oil hydrostatic slides. The maximum radial swing for this machine is approximately 0.3 meters.
- Research Organization:
- Oak Ridge National Lab. (ORNL), Oak Ridge, TN (United States)
- Sponsoring Organization:
- USDOE, Washington, DC (United States)
- DOE Contract Number:
- AC05-84OR21400
- OSTI ID:
- 205186
- Report Number(s):
- CONF-951056-4; ON: DE96005487
- Resource Relation:
- Conference: 10. annual meeting of the American Society for Precision Engineering, Austin, TX (United States), 15-20 Oct 1995; Other Information: PBD: [1995]
- Country of Publication:
- United States
- Language:
- English
Similar Records
Electromagnetic variable degrees of freedom actuator systems and methods
Rotary fast tool servo system and methods