Influence of NOx Chemistry on the Prediction of Natural Gas End-Gas Autoignition
Research on the influence of NOx (NO/NO2) chemistry on HC oxidation has shown that NOx plays an important role in the promotion/inhibition of HC autoignition [1-6]. Current data for n-heptane, iso-octane, ethanol, and toluene [3, 4] have shown that NO chemistry inhibits autoignition at low temperatures and concentrations. However, at medium and high temperatures and low concentrations, autoignition is promoted, decreasing the Negative Temperature Coefficient (NTC) effect. This autoignition promotion, however, becomes weaker as NO concentrations are increased. Additionally, fundamental kinetics studies have suggested that NOx chemistry also promotes the autoignition of smaller HC, such as CH4 [7-10], C2H6 [11-14], and C3H8 [15]. Additionally to the chemical kinetics studies, a growing body of evidence supports the importance of NOx chemistry on SI engine simulations [16, 17]. Foong et al. [18] suggested that the addition of NO in their models significantly improved the agreement between simulations and experiments where the onset of knock was advanced due to the presence of NO, and Morganti et al. [19] showed that NO addition in the residual-gas was necessary for their models to obtain good agreement with experimental data. Lastly, Mohr et al. [20, 21] investigated the effect of Natural Gas (NG) reactivity and EGR substitution rate and composition on homogeneous ignition delay, flame speeds, and EGAI for stoichiometric NG/oxidizer/EGR blends. They observed that the addition of EGR composed of only inert species (CO2 and Ar) suppressed homogeneous autoignition in all NG fuels tested under all conditions. However, for all NG fuels tested, increasing EGR rates with reactive species (Ar, CO2, CO, and NO) promoted homogeneous autoignition under all conditions, thus reproducing the same trends for various NG fuel compositions that were observed in other studies and fuels. For this reason, a study is being conducted to analyze the effects of NOx chemistry on the prediction of NG/air/EGR homogeneous autoignition. This study has been divided into two tasks. First, the addition of NOx chemistry to the ARIES82 mechanism [20] is being validated using homogeneous ignition delay data collected by Mohr [20, 21]. Second, once the new modified mechanism with NOx reactions has been validated, it will be employed on engine multi-dimensional modeling presented in [22, 23] to analyze the influence of NOx chemistry on NG EGAI. Results thus far have shown that homogeneous ignition delay calculations are sensitive to NOx chemistry, where the modified mechanisms captured well all trends and closely matched the homogeneous ignition delays observed by Mohr et al. Also, the results in this work suggest that NOx chemistry is necessary to correctly capture the trends in NG homogeneous autoignition when EGR with reactive species is used since the opposite behavior is observed when only inert species are considered for the EGR composition.
- Research Organization:
- Colorado State Univ., Fort Collins, CO (United States)
- Sponsoring Organization:
- USDOE Office of Energy Efficiency and Renewable Energy (EERE)
- DOE Contract Number:
- EE0008331
- OSTI ID:
- 1810756
- Report Number(s):
- 128RK-0213
- Resource Relation:
- Conference: 12th U. S. National Combustion Meeting May 24–26, 2021 (Virtual) College Station, Texas
- Country of Publication:
- United States
- Language:
- English
Similar Records
Autoignition of Premixed Liquefied Petroleum Gas in a Rapid Compression Machine: Experimental Results and Chemical Kinetic Mechanism Reduction
Ignition, Flame Propagation, and End-Gas Autoignition Studies of Natural Gas/EGR Blends in a Rapid Compression Machine