skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: In situ recombination junction between p-Si and TiO2 enables high-efficiency monolithic perovskite/Si tandem cells

Journal Article · · Science Advances
ORCiD logo [1]; ORCiD logo [2]; ORCiD logo [1];  [2]; ORCiD logo [1]; ORCiD logo [1];  [1];  [1]; ORCiD logo [1]; ORCiD logo [3];  [1];  [1];  [1]; ORCiD logo [1]; ORCiD logo [3]; ORCiD logo [2]; ORCiD logo [1]
  1. Australian National Univ., Canberra, ACT (Australia)
  2. California Institute of Technology (CalTech), Pasadena, CA (United States)
  3. Flinders Univ., Adelaide, SA (Australia)

Increasing the power conversion efficiency of silicon (Si) photovoltaics is a key enabler for continued reductions in the cost of solar electricity. Here, we describe a two-terminal perovskite/Si tandem design that increases the Si cell’s output in the simplest possible manner: by placing a perovskite cell directly on top of the Si bottom cell. The advantageous omission of a conventional interlayer eliminates both optical losses and processing steps and is enabled by the low contact resistivity attainable between n-type TiO2 and Si, established here using atomic layer deposition. We fabricated proof-of-concept perovskite/Si tandems on both homojunction and passivating contact heterojunction Si cells to demonstrate the broad applicability of the interlayer-free concept. Stabilized efficiencies of 22.9 and 24.1% were obtained for the homojunction and passivating contact heterojunction tandems, respectively, which could be readily improved by reducing optical losses elsewhere in the device. This work highlights the potential of emerging perovskite photovoltaics to enable low-cost, high-efficiency tandem devices through straightforward integration with commercially relevant Si solar cells.

Research Organization:
California Institute of Technology (CalTech), Pasadena, CA (United States)
Sponsoring Organization:
USDOE Office of Science (SC); Australian Research Council; Australian Renewable Energy Agency (ARENA)
Grant/Contract Number:
SC0004993; LE0989068; MG005; FT13010916
OSTI ID:
1610792
Journal Information:
Science Advances, Vol. 4, Issue 12; ISSN 2375-2548
Publisher:
AAASCopyright Statement
Country of Publication:
United States
Language:
English
Citation Metrics:
Cited by: 113 works
Citation information provided by
Web of Science

References (44)

Composition-Tuned Wide Bandgap Perovskites: From Grain Engineering to Stability and Performance Improvement journal July 2018
A Biopolymer Heparin Sodium Interlayer Anchoring TiO 2 and MAPbI 3 Enhances Trap Passivation and Device Stability in Perovskite Solar Cells journal April 2018
Tailored interfaces of unencapsulated perovskite solar cells for >1,000 hour operational stability journal January 2018
Silicon heterojunction solar cell with interdigitated back contacts for a photoconversion efficiency over 26% journal March 2017
Nanophotonic light trapping in solar cells journal November 2012
23.6%-efficient monolithic perovskite/silicon tandem solar cells with improved stability journal February 2017
Ohmic contacts for GaAs devices journal December 1967
Improved Optics in Monolithic Perovskite/Silicon Tandem Solar Cells with a Nanocrystalline Silicon Recombination Junction journal October 2017
Inorganic CsPbI 3 Perovskite-Based Solar Cells: A Choice for a Tandem Device journal June 2017
Iodide management in formamidinium-lead-halide–based perovskite layers for efficient solar cells journal June 2017
Organometal Halide Perovskites as Visible-Light Sensitizers for Photovoltaic Cells journal May 2009
Perovskite/Silicon Tandem Solar Cells: Marriage of Convenience or True Love Story? - An Overview journal September 2017
Accuracy of analytical expressions for solar cell fill factors journal December 1982
Rubidium Multication Perovskite with Optimized Bandgap for Perovskite-Silicon Tandem with over 26% Efficiency journal April 2017
Interfacial Modification for High-Efficiency Vapor-Phase-Deposited Perovskite Solar Cells Based on a Metal Oxide Buffer Layer journal February 2018
Design guidelines for perovskite/silicon 2-terminal tandem solar cells: an optical study journal January 2016
Hole-blocking crystalline-silicon/titanium-oxide heterojunction with very low interface recombination velocity conference June 2013
Electrical characterization of Pb centers in (100)Si–SiO2 structures: The influence of surface potential on passivation during post metallization anneal journal July 2000
Increased efficiency in multijunction solar cells through the incorporation of semimetallic ErAs nanoparticles into the tunnel junction journal April 2006
Energy band alignment at TiO2∕Si interface with various interlayers journal February 2008
Large area efficient interface layer free monolithic perovskite/homo-junction-silicon tandem solar cell with over 20% efficiency journal January 2018
Passivating contacts for silicon solar cells based on boron-diffused recrystallized amorphous silicon and thin dielectric interlayers journal August 2016
Efficient Hybrid Solar Cells Based on Meso-Superstructured Organometal Halide Perovskites journal October 2012
Fully textured monolithic perovskite/silicon tandem solar cells with 25.2% power conversion efficiency journal June 2018
Amorphous TiO2 coatings stabilize Si, GaAs, and GaP photoanodes for efficient water oxidation journal May 2014
The physics and chemistry of the Schottky barrier height journal January 2014
Raising the one-sun conversion efficiency of III–V/Si solar cells to 32.8% for two junctions and 35.9% for three junctions journal August 2017
Monolithic perovskite/silicon-homojunction tandem solar cell with over 22% efficiency journal January 2017
Incorporation of rubidium cations into perovskite solar cells improves photovoltaic performance journal September 2016
Effect of Selective Contacts on the Thermal Stability of Perovskite Solar Cells journal February 2017
Interface passivation using ultrathin polymer–fullerene films for high-efficiency perovskite solar cells with negligible hysteresis journal January 2017
A 2-terminal perovskite/silicon multijunction solar cell enabled by a silicon tunnel junction journal March 2015
Monolithic perovskite/silicon-heterojunction tandem solar cells processed at low temperature journal January 2016
Mechanically-stacked perovskite/CIGS tandem solar cells with efficiency of 23.9% and reduced oxygen sensitivity journal January 2018
The Influence of Structure and Processing on the Behavior of TiO 2 Protective Layers for Stabilization of n-Si/TiO 2 /Ni Photoanodes for Water Oxidation journal July 2015
Overcoming ultraviolet light instability of sensitized TiO2 with meso-superstructured organometal tri-halide perovskite solar cells journal December 2013
Passivating Contacts for Crystalline Silicon Solar Cells: From Concepts and Materials to Prospects journal March 2018
Structural features and their functions in surfactant-armoured methylammonium lead iodide perovskites for highly efficient and stable solar cells journal January 2018
Lead Iodide Perovskite Sensitized All-Solid-State Submicron Thin Film Mesoscopic Solar Cell with Efficiency Exceeding 9% journal August 2012
Efficient Monolithic Perovskite/Silicon Tandem Solar Cell with Cell Area >1 cm 2 journal December 2015
Low temperature crystallisation of mesoporous TiO2 journal January 2013
Systematic investigation of the impact of operation conditions on the degradation behaviour of perovskite solar cells journal January 2018
Ohmic contacts for GaAs devices conference January 1966
Perovskites cover silicon textures journal June 2018

Cited By (3)

Defect and Contact Passivation for Perovskite Solar Cells journal April 2019
Monolithic Perovskite/Si Tandem Solar Cells: Pathways to Over 30% Efficiency journal April 2020
Light Management in Monolithic Perovskite/Silicon Tandem Solar Cells journal August 2019