Techno-Economic Analysis of a Megawatt-Scale Thermoplastic Resin Wind Turbine Blade
Two-part, in-situ reactive thermoplastic resin systems for composite wind turbine blades have the potential to lower the blade cost by decreasing cycle times, capital costs of both tooling and equipment, and energy consumption during manufacturing, and enabling recycling at the end of the blade life. This paper describes a techno-economic model used to estimate the cost of a thermoplastic wind turbine blade relative to a baseline thermoset epoxy blade. It was shown that a 61.5-m thermoplastic blade costs 4.7% less than an equivalent epoxy blade. Even though the thermoplastic resin is currently more expensive than epoxy, this cost reduction is primarily driven by the decreased capital costs, faster cycle times, and reduced energy requirements and labor costs. Although thermoplastic technology for resin infusion of wind turbine blades is relatively new, these results suggest that it is economically and technically feasible and warrants further research.
- Research Organization:
- National Renewable Energy Lab. (NREL), Golden, CO (United States)
- Sponsoring Organization:
- USDOE Office of Energy Efficiency and Renewable Energy (EERE), Institute for Advanced Composites Manufacturing and Innovation (IACMI); USDOE Office of Energy Efficiency and Renewable Energy (EERE), Wind and Water Technologies Office (EE-4W)
- DOE Contract Number:
- AC36-08GO28308
- OSTI ID:
- 1487323
- Report Number(s):
- NREL/JA-5000-70747
- Journal Information:
- Renewable Energy, Vol. 131, Issue C; ISSN 0960-1481
- Publisher:
- Elsevier
- Country of Publication:
- United States
- Language:
- English
Similar Records
Infusible thermoplastic resin based sandwich structures for wind blade applications and the influence of scrim on facesheet to core interface debonding
Manufacturing a 9-Meter Thermoplastic Composite Wind Turbine Blade: Preprint