skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Alkali-activated materials: cementing a sustainable future

; ;  [1];  [2]
  1. (Sheffield)
  2. (
Publication Date:
Research Org.:
Argonne National Lab. (ANL), Argonne, IL (United States). Advanced Photon Source (APS)
Sponsoring Org.:
OSTI Identifier:
Resource Type:
Journal Article
Resource Relation:
Journal Name: Ing. Compet.; Journal Volume: 15; Journal Issue: (2) ; 2013
Country of Publication:
United States

Citation Formats

Bernal, Susan A., Mejía de Gutierrez, Ruby, Rodríguez, Erich D., and U del Valle). Alkali-activated materials: cementing a sustainable future. United States: N. p., 2017. Web.
Bernal, Susan A., Mejía de Gutierrez, Ruby, Rodríguez, Erich D., & U del Valle). Alkali-activated materials: cementing a sustainable future. United States.
Bernal, Susan A., Mejía de Gutierrez, Ruby, Rodríguez, Erich D., and U del Valle). 2017. "Alkali-activated materials: cementing a sustainable future". United States. doi:.
title = {Alkali-activated materials: cementing a sustainable future},
author = {Bernal, Susan A. and Mejía de Gutierrez, Ruby and Rodríguez, Erich D. and U del Valle)},
abstractNote = {},
doi = {},
journal = {Ing. Compet.},
number = (2) ; 2013,
volume = 15,
place = {United States},
year = 2017,
month = 4
  • Pore solution chemistry (high pressure extraction method) of cement pastes made with two condensed silica fumes, three pulverized fly ashes and one ground granulated blast furnace slag was measured after 7, 28, 84, 182, 364 and 545 days of curing (38 C and 100% R.H.). Results were compared to expansions obtained for a 2 year time period in the CAN/CSA A23.2-14A Concrete Prism Method for concrete specimens made with two very alkali-silica reactive aggregates and tested at the same conditions and water/cement/SCM (supplementary cementing materials). A long-term threshold in alkali hydroxide concentration was observed around 0.65N, below which no significantmore » expansion occurred in corresponding concretes. The lower the SCM alkali content and the concrete alkali content as well, and the higher the SCM content, the easier this limit is satisfied.« less
  • The alkali activation of waste materials (especially those coming from industrial and mining activities) has become an important area of research in many laboratories because it is possible to use these materials to synthesize inexpensive and ecologically sound cementlike construction materials. In the present paper, the mechanisms of activation of a fly ash (no other solid material was used) with highly alkaline solutions is described. These solutions, made with NaOH, KOH, water glass, etc., have the common characteristic of having a very high OH{sup {minus}} concentration. The product of the reaction is an amorphous aluminosilicate gel having a structure similarmore » to that of zeolitic precursors. Temperature and time of curing of specimens together with the solution/fly ash ratio are some of the variables that were studied. These variables have been shown to notably influence the development of the mechanical strength of the final product. Mechanical strengths with values in the 60 MPa range were obtained after curing the fly ash at 85 C for only 5 h.« less
  • The current annual worldwide energy consumption stands at about 15 terawatts (TW, x1012 watts). Approximately 80% of it is supplied from fossil fuels: oil (34 %), coal (25 %), and natural gas (21 %). Biomass makes up 8% of the energy supply, nuclear energy accounts for 6.5 %, hydropower has a 2% share and other technologies such as wind and solar make up the rest. Even with aggressive conservation and new higher efficiency technology development, worldwide energy demand is predicted to double to 30 TW by 2050 and triple to 46 TW by the end of the century. Meanwhile oilmore » and natural gas production is predicted to peak over the next few decades. Abundant coal reserves may maintain the current consumption level for longer period of time than the oil and gas. However, burning the fossil fuels leads to a serious environmental consequence by emitting gigantic amount of green house gases, particularly CO2 emissions which are widely considered as the primary contributor to global warming. Because of the concerns over the greenhouse gas emission, many countries, and even some states and cities in the US, have adopted regulations for limiting CO2 emissions. Along with increased CO2 regulations, is an emerging trend toward carbon “trading,” giving benefits to low “carbon footprint” industries, while making higher emitting industries purchase carbon “allowances”. There have been an increasing number of countries and states adopting the trade and cap systems.« less
  • Forest-derived biomaterials can play an integral role in a sustainable and renewable future. Research across a range of disciplines is required to develop the knowledge necessary to overcome the challenges of incorporating more renewable forest resources in materials, chemicals, and fuels. We focus on wood specifically because in our view, better characterization of wood as a raw material and as a feedstock will lead to its increased utilization. We first give an overview of wood structure and chemical composition and then highlight current topics in forest products research, including (1) industrial chemicals, biofuels, and energy from woody materials; (2) wood-basedmore » activated carbon and carbon nanostructures; (3) development of improved wood protection treatments; (4) massive timber construction; (5) wood as a bioinspiring material; and (6) atomic simulations of wood polymers. We conclude with a discussion of the sustainability of wood as a renewable forest resource.« less