skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Confocal (micro)-XRF for 3D anlaysis of elements distribution in hot environmental particles

Technical Report ·
DOI:https://doi.org/10.2172/924005· OSTI ID:924005

Studies on the fate and transport of radioactive contaminates in the environment are often constrained by a lack of knowledge on the elemental distribution and general behavior of particulate bound radionuclides contained in hot particles. A number of hot particles were previously isolated from soil samples collected at former U.S. nuclear test sites in the Marshall Islands and characterized using non-destructive techniques [1]. The present investigation at HASYLAB is a part of larger research program at ITU regarding the characterization of environmental radioactive particles different locations and source-terms. Radioactive particles in the environment are formed under a number of different release scenarios and, as such, their physicochemical properties may provide a basis for identifying source-term specific contamination regimes. Consequently, studies on hot particles are not only important in terms of studying the elemental composition and geochemical behavior of hot particles but may also lead to advances in assessing the long-term impacts of radioactive contamination on the environment. Six particles isolated from soil samples collected at the Marshall Islands were studied. The element distribution in the particles was determined by confocal {micro}-XRF analysis using the ANKA FLUO beam line. The CRL (compound refractive lens) was used to focus the exciting beam and the polycapillary half lens to collimate the detector. The dimensions of confocal spot were measured by 'knife edge scanning' method with thin gold structure placed at Si wafer. The values of 3.1 x 1.4 x 18.4 {micro}m were achieved if defined as FWHMs of measured L?intensity profiles and when the19.1 keV exciting radiation was used. The collected XRF spectra were analyzed offline with AXIL [2] software to obtain net intensities of element characteristic lines.Further data processing and reconstruction of element distribution was done with the software 'R' [3] dedicated for statistical calculations. In figure 1 the distributions of Pu, Fe and Ti obtained for one of the studied hot particles are presented. The strongest signal was recorded for plutonium; the signals from iron and titanium are respectively 14 and 38 times less. It means that Pu is the most abundant of the observed elements. However, since the light elements are not detectable with the applied measurement conditions, it cannot be definitely stated if plutonium is the main element present in the sample. The isosurfaces are calculated at 20 % of maximum intensity for each element. Please note that the isosurfaces on the drawing are transparent. Changes in the spatial distribution of Pu, Fe, and Ti within the particle are shown in Fig. 2a, 2b, and 2c. Distinct elemental patterns are clearly visible at the higher concentration levels. The distributions of Cr, Cu, and Pb were also reconstructed but the results are not presented here. As it is shown in Fig. 1, the correlation between elements is good at low concentrations but the maxima of concentrations are not strongly correlated (see Fig. 2.). In general, the particle is inhomogeneous in terms of its elemental composition. Similar inhomogeneities were found for other particles with Pu identified as a major element in three of the six particles examined.

Research Organization:
Lawrence Livermore National Lab. (LLNL), Livermore, CA (United States)
Sponsoring Organization:
USDOE
DOE Contract Number:
W-7405-ENG-48
OSTI ID:
924005
Report Number(s):
LLNL-TR-400056; TRN: US0802236
Country of Publication:
United States
Language:
English