Review of arsenic removal technologies for contaminated groundwaters.
This review was compiled to summarize the technologies currently being investigated to remove arsenic from drinking waters, with a special focus on developing and third-world countries where the problem is exacerbated by flooding and depressed economic conditions. The reason for compiling this report is to provide background material and a description of competing technologies currently described in the literature for arsenic removal. Based on the sophistication and applicability of current technologies, Argonne National Laboratory may develop an improved method based on magnetic particle technology. Magnetic particle sorbents may afford improved reaction rates, facilitate particle-water separation, and offer reusability. Developing countries like Vietnam and Bangladesh cannot afford expensive, large-scale treatments to remove arsenic from drinking waters to acceptable limits (from 50 ppb to 10 ppb, depending on the country). Low-cost, effective technologies that can be readily available at the household or community level are needed to solve the present crisis. Appropriate technologies should meet certain criteria, including the following: The treatment must be applicable over a wide range of arsenic concentrations; It should be easy to use without running water or electricity; and The materials for the treatment should be cheap and readily available, and/or suitable for reuse. Our review of arsenic removal technologies and procedures indicates that iron filings, ferric salts, granular ferric hydroxide, alumina manganese oxide, Aqua-bind., and Kimberlite tailings are potentially low-cost sorbents that can remove arsenic after simple mixing in a relatively short time. However, all these technologies suffer from significant shortcomings. Ferric salts are cheap and very effective at removing arsenic but the reaction rates are slow. Fixed-bed columns make use of activated alumina and iron-coated sands but do not work well with groundwater having high concentrations of iron because iron precipitates in the presence of air, which could clog and foul the column. Synthetic sorbents are highly selective and effective and do not pose a significant waste disposal concern because they are generally non-hazardous. Aqua-bind. is perhaps the most effective synthetic sorbent available for removing arsenic, but it must be mass-produced to realize low cost. Naturally occurring solids are cheap and remove arsenic well; however, the removal rate is often very slow and the solids can harbor bacteria. This report reviews competing technologies for removal of water-borne arsenic to establish a baseline for technology improvements. Specifically, the information in this report will serve as a basis for developing a low-cost separation technology using functionalized magnetic particles to adsorb arsenic and permanent magnets to separate the arsenic-loaded magnetic particles from the cleaned water.
- Research Organization:
- Argonne National Lab., IL (US)
- Sponsoring Organization:
- US Department of Energy (US)
- DOE Contract Number:
- W-31-109-ENG-38
- OSTI ID:
- 815660
- Report Number(s):
- ANL-CMT-03/2; TRN: US200320%%132
- Resource Relation:
- Other Information: PBD: 2 May 2003
- Country of Publication:
- United States
- Language:
- English
Similar Records
Design of a rural water provision system to decrease arsenic exposure in Bangladesh
Removing Arsenic from Contaminated Drinking Water in Rural Bangladesh: Recent Fieldwork Results and Policy Implications