Towards automatic planning for manufacturing generative processes
Generative process planning describes methods process engineers use to modify manufacturing/process plans after designs are complete. A completed design may be the result from the introduction of a new product based on an old design, an assembly upgrade, or modified product designs used for a family of similar products. An engineer designs an assembly and then creates plans capturing manufacturing processes, including assembly sequences, component joining methods, part costs, labor costs, etc. When new products originate as a result of an upgrade, component geometry may change, and/or additional components and subassemblies may be added to or are omitted from the original design. As a result process engineers are forced to create new plans. This is further complicated by the fact that the process engineer is forced to manually generate these plans for each product upgrade. To generate new assembly plans for product upgrades, engineers must manually re-specify the manufacturing plan selection criteria and re-run the planners. To remedy this problem, special-purpose assembly planning algorithms have been developed to automatically recognize design modifications and automatically apply previously defined manufacturing plan selection criteria and constraints.
- Research Organization:
- Sandia National Lab. (SNL-NM), Albuquerque, NM (United States); Sandia National Lab. (SNL-CA), Livermore, CA (United States)
- Sponsoring Organization:
- US Department of Energy (US)
- DOE Contract Number:
- AC04-94AL85000
- OSTI ID:
- 756163
- Report Number(s):
- SAND2000-1312C; TRN: AH200021%%208
- Resource Relation:
- Conference: International Association of Science and Technology for Development, Cancun (MX), 05/24/2000--05/27/2000; Other Information: PBD: 24 May 2000
- Country of Publication:
- United States
- Language:
- English
Similar Records
On the Automatic Generation of Plans for Life Cycle Assembly Processes
Materials for Advanced Ultrasupercritical Steam Turbines Task 4: Cast Superalloy Development