Demonstration of variable speed permanent magnet generator at small, low-head hydro site
- Shaker Landing Hydro Associates, Inc., Louisville, KY (United States)
Small hydro developers face a limited set of bad choices when choosing a generator for a small low-head hydro site. Direct drive synchronous generators are expensive and technically complex to install. Simpler induction generators are higher speed, requiring a speed increaser, which results in inefficiencies and maintenance problems. In addition, both induction and synchronous generators turn at a fixed speed, causing the turbine to run off its peak efficiency curve whenever the available head is different than the designed optimum head.The solution to these problems is the variable speed Permanent Magnet Generators (PMG). At the Weisenberger Mill in Midway, KY, a variable speed Permanent Magnet Generator has been installed and demonstrated. This new PMG system replaced an existing induction generator that had a HTD belt drive speed increaser system. Data was taken from the old generator before it was removed and compared to data collected after the PMG system was installed. The new variable speed PMG system is calculated to produce over 96% more energy than the old induction generator system during an average year. This significant increase was primarily due to the PMG generator operating at the correct speed at the maximum head, and the ability for the PMG generator to reduce its speed to lower optimum speeds as the stream flow increased and the net head decreased.This demonstration showed the importance of being able to adjust the speed of fixed blade turbines. All fixed blade turbines with varying net heads could achieve higher efficiencies if the speed can be matched to the optimum speed as the head changes. In addition, this demonstration showed that there are many potential efficiencies that could be realized with variable speed technology at hydro sites where mismatched turbine and generator speeds result in lower power output, even at maximum head. Funding for this project came from the US Dept. of Energy, through Award Number DE-EE0005429.
- Research Organization:
- Weisenberger Mills, Inc., Midway, KY (United States)
- Sponsoring Organization:
- USDOE Office of Energy Efficiency and Renewable Energy (EERE), Wind and Water Technologies Office (EE-4W)
- Contributing Organization:
- Shaker Landing Hydro Associates, Inc., Louisville, KY (United States)
- DOE Contract Number:
- EE0005429
- OSTI ID:
- 1230014
- Report Number(s):
- Final Report: DOE - WEISENBERGER- EE0005429-1; 5025890975
- Country of Publication:
- United States
- Language:
- English
Similar Records
Permanent Magnet Synchronous Motors for Commercial Refrigeration (Final Report)
Optimized Generator Designs for the DTU 10-MW Offshore Wind Turbine using GeneratorSE