EC Hidraulic Drive Cylinder Relief Vlave Test
This engineering note documents the testing of the set pressure of the EC hydraulic drive cylinder relief valve. The purpose of the relief valve is to provide a safety measure in the event that oil becomes trapped in the rod side of the cylinder and pressure is applied to the cap side. The note includes an explanation of the procedure used and a summary of the result of the testing done on February 14, 1991 by Gary Trotter. The result was that the cylinder relief valve relieved at the correct set pressure of 10,500 psig. The basic concern is for the protection of the cylinder. The pump is capable of providing up to 10,500 psi of pressure to either side of the cylinder. The cylinder is rated for 10,500 psi. Under normal operating conditions, the valves would be open, and the pumping pressure would automatically flow oil into one side, and remove oil from the other side. If, however, the valve for the other side was closed, so that oil could not be removed, then the pressure would build in that side. If the rod side is pressurized to the maximum pump pressure of 10,500 psi, the cross sectional area ratio of 2.29 results in a pressure of approximately 4600 psi in the cap side, which is well under the rated pressure. If, however, the cap side is pressurized to 10,500 psi, the cross sectional area would produce a pressure of approximately 24,000 psi in the rod side, which could damage the cylinder. Therefore, the pressure on the rod side must be limited to the rated pressure of 10,500 psi. In reality, the maximum operating force on the piston would be under 11,000 Ibs., which would result in the maximum cylinder pressure being under 8000 psi to the rod side, and under 3500 psi to the cap side. Therefore, the relief is only needed as a safety precaution in the case that oil becomes trapped.
- Research Organization:
- Fermi National Accelerator Lab. (FNAL), Batavia, IL (United States)
- Sponsoring Organization:
- USDOE Office of Science (SC)
- DOE Contract Number:
- AC02-07CH11359
- OSTI ID:
- 1031801
- Report Number(s):
- FERMILAB-D0-EN-298; TRN: US201201%%991
- Country of Publication:
- United States
- Language:
- English
Similar Records
EC Driver - 41" Stroke Hydraulic Cylinder
D0 Solenoid Upgrade Project: Solenoid Insulatiing Vacuum Vessels; Relief Path Capacity Calculation