Evaluation of helium cooling for fusion divertors
The divertors of future fusion reactors will have a power throughput of several hundred MW. The peak heat flux on the diverter surface is estimated to be 5 to 15 MW/m{sup 2} at an average heat flux of 2 MW/m{sup 2}. The divertors have a requirement of both minimum temperature (100{degrees}C) and maximum temperature. The minimum temperature is dictated by the requirement to reduce the absorption of plasma, and the maximum temperature is determined by the thermo-mechanical properties of the plasma facing materials. Coolants that have been considered for fusion reactors are water, liquid metals and helium. Helium cooling has been shown to be very attractive from safety and other considerations. Helium is chemically and neutronically inert and is suitable for power conversion. The challenges associated with helium cooling are: (1) Manifold sizes; (2) Pumping power; and (3) Leak prevention. In this paper the first two of the above design issues are addressed. A variety of heat transfer enhancement techniques are considered to demonstrate that the manifold sizes and the pumping power can be reduced to acceptable levels. A helium-cooled diverter module was designed and fabricated by GA for steady-state heat flux of 10 MW/m{sup 2}. This module was recently tested at Sandia National Laboratories. At an inlet pressure of 4 MPa, the module was tested at a steady-state heat flux of 10 MW/m{sup 2}. The pumping power required was less than 1% of the power removed. These results verified the design prediction.
- Research Organization:
- General Atomics Co., San Diego, CA (United States)
- Sponsoring Organization:
- USDOE, Washington, DC (United States)
- DOE Contract Number:
- AC03-89ER51114
- OSTI ID:
- 10104403
- Report Number(s):
- GA-A-21448; CONF-9309274-1; ON: DE94002680; BR: 35AT10020/AT0520210; TRN: 94:000762
- Resource Relation:
- Conference: International Atomic Energy Agency (IAEA) meeting on fusion reactor design and technology,Los Angeles, CA (United States),13-17 Sep 1993; Other Information: PBD: Sep 1993
- Country of Publication:
- United States
- Language:
- English
Similar Records
Design, fabrication, and testing of a helium-cooled module for the ITER divertor
Recent progress in the design of the K-DEMO divertor