skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: A Josephson junction to FET high speed line driver made of TlCaBaCuO

Conference · · IEEE Transactions on Magnetics (Institute of Electrical and Electronics Engineers); (United States)
OSTI ID:5923675
;  [1]; ;  [2];  [3]
  1. Sandia National Labs., Albuquerque, NM (United States)
  2. Wisconsin Univ., Madison, WI (United States). Dept. of Electrical and Computer Engineering
  3. Hypres, Inc., Elmsford, NY (United States)

This paper reports on the use of a Tl-Ca-Ba- Cu-O superconducting flux flow transistor (SFFT) as an active impedance converter between Josephson and FET circuitry. The input of the flux flow device is a control line of low impedance that can be driven by a tunnel junction. The output is the signal across the SFFT which is made of a parallel array of weak links. The output impedance is typically greater than 5 {Omega} with a maximum voltage swing of over 100 mV into a 50 {Omega} system. The switching of an all-Nb junction induced a 90 mV voltage swing at the FET input and over 200 mV at the FET output. The line driver can operate anywhere between 4.2K and 85K with minor changes in speed ({plus minus}5 ps) and output level ({plus minus}10 mV). The switching time measured was about 100 ps and was fixture limited.

OSTI ID:
5923675
Report Number(s):
CONF-900944-; CODEN: IEMGA
Journal Information:
IEEE Transactions on Magnetics (Institute of Electrical and Electronics Engineers); (United States), Vol. 27:2; Conference: 1990 applied superconductivity conference, Snowmass, CO (United States), 24-28 Sep 1990; ISSN 0018-9464
Country of Publication:
United States
Language:
English