skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Pitting corrosion protection of stainless steel by sputter deposited hafnia, alumina, and hafnia-alumina nanolaminate films

Abstract

316L stainless steel coated with sputter deposited HfO{sub 2}, Al{sub 2}O{sub 3}, and HfO{sub 2}-Al{sub 2}O{sub 3} nanolaminate films were subjected to direct current cyclic potentiodynamic polarization (DCP) in Hanks' balanced salt solution electrolyte. Postexposure morphology was characterized by scanning electron microscopy (SEM) with in situ energy dispersive spectroscopy (EDS). SEM/EDS data show that bare steel and steel coated with single-layer HfO{sub 2} develop pits with perforated covers. These pits become autocatalytic, consistent with an observed positive DCP hysteresis. On the other hand, SEM/EDS data show that steel coated with Al{sub 2}O{sub 3} and HfO{sub 2}-Al{sub 2}O{sub 3} nanolaminate films does not develop autocatalytic pits, consistent with an observed negative DCP hysteresis. However, Al{sub 2}O{sub 3} splinters upon polarization whereas the HfO{sub 2}-Al{sub 2}O{sub 3} nanolaminate remains intact. The areas of worst damage in the nanolaminate correspond to pit cover rupture before autocatalysis, allowing pit and bulk electrolyte to mix and the newly exposed steel surface to repassivate. The films' diverse behavior is discussed in terms of a model for perforated pit growth that requires occlusion until an autocatalytic geometry is established. The authors conclude that the key property a film must have to arrest autocatalytic geometry development is themore » ability to rupture locally at an early stage of pit growth.« less

Authors:
;  [1]
  1. Materials Department and the Advanced Coatings Experimental Laboratory, College of Engineering and Applied Science, University of Wisconsin-Milwaukee, P.O. Box 784, Milwaukee, Wisconsin 53201 (United States)
Publication Date:
OSTI Identifier:
22050983
Resource Type:
Journal Article
Journal Name:
Journal of Vacuum Science and Technology. A, International Journal Devoted to Vacuum, Surfaces, and Films
Additional Journal Information:
Journal Volume: 27; Journal Issue: 3; Other Information: (c) 2009 American Vacuum Society; Country of input: International Atomic Energy Agency (IAEA); Journal ID: ISSN 1553-1813
Country of Publication:
United States
Language:
English
Subject:
36 MATERIALS SCIENCE; ALUMINIUM OXIDES; DIRECT CURRENT; HAFNIUM OXIDES; HYSTERESIS; LAYERS; MORPHOLOGY; NANOSTRUCTURES; PITTING CORROSION; POLARIZATION; SCANNING ELECTRON MICROSCOPY; SPECTROSCOPY; SPUTTERING; STAINLESS STEEL-316L; SURFACE COATING; THIN FILMS

Citation Formats

Almomani, M A, and Aita, C R. Pitting corrosion protection of stainless steel by sputter deposited hafnia, alumina, and hafnia-alumina nanolaminate films. United States: N. p., 2009. Web. doi:10.1116/1.3100216.
Almomani, M A, & Aita, C R. Pitting corrosion protection of stainless steel by sputter deposited hafnia, alumina, and hafnia-alumina nanolaminate films. United States. https://doi.org/10.1116/1.3100216
Almomani, M A, and Aita, C R. 2009. "Pitting corrosion protection of stainless steel by sputter deposited hafnia, alumina, and hafnia-alumina nanolaminate films". United States. https://doi.org/10.1116/1.3100216.
@article{osti_22050983,
title = {Pitting corrosion protection of stainless steel by sputter deposited hafnia, alumina, and hafnia-alumina nanolaminate films},
author = {Almomani, M A and Aita, C R},
abstractNote = {316L stainless steel coated with sputter deposited HfO{sub 2}, Al{sub 2}O{sub 3}, and HfO{sub 2}-Al{sub 2}O{sub 3} nanolaminate films were subjected to direct current cyclic potentiodynamic polarization (DCP) in Hanks' balanced salt solution electrolyte. Postexposure morphology was characterized by scanning electron microscopy (SEM) with in situ energy dispersive spectroscopy (EDS). SEM/EDS data show that bare steel and steel coated with single-layer HfO{sub 2} develop pits with perforated covers. These pits become autocatalytic, consistent with an observed positive DCP hysteresis. On the other hand, SEM/EDS data show that steel coated with Al{sub 2}O{sub 3} and HfO{sub 2}-Al{sub 2}O{sub 3} nanolaminate films does not develop autocatalytic pits, consistent with an observed negative DCP hysteresis. However, Al{sub 2}O{sub 3} splinters upon polarization whereas the HfO{sub 2}-Al{sub 2}O{sub 3} nanolaminate remains intact. The areas of worst damage in the nanolaminate correspond to pit cover rupture before autocatalysis, allowing pit and bulk electrolyte to mix and the newly exposed steel surface to repassivate. The films' diverse behavior is discussed in terms of a model for perforated pit growth that requires occlusion until an autocatalytic geometry is established. The authors conclude that the key property a film must have to arrest autocatalytic geometry development is the ability to rupture locally at an early stage of pit growth.},
doi = {10.1116/1.3100216},
url = {https://www.osti.gov/biblio/22050983}, journal = {Journal of Vacuum Science and Technology. A, International Journal Devoted to Vacuum, Surfaces, and Films},
issn = {1553-1813},
number = 3,
volume = 27,
place = {United States},
year = {Fri May 15 00:00:00 EDT 2009},
month = {Fri May 15 00:00:00 EDT 2009}
}